Want this question answered?
== == == ==
In cylinder
right nest to header is the clutch slave cylinder it has a bleeder screw
It is located on the clutch slave cylinder. The slave cylinder is mounted on top of the transmission. Have someone push on the clutch cable and you will see movement on the cylinder.
if youre referring to the bleeder valve, its on the clutch slave cylinder bolted to the transmission
after the clutch master cylinder has been replaced.
yes,open bleeder valve on cluch slave cylinder and clutch damper to release air.
Open bleeder on the clutch slave cylinder and bleed the system. Follow the line from the clutch master cylinder reservoir to the slave cylinder. There you will find the bleeder valve on the slav cylinder. Follow this procedure to properly bleed the hydraulic clutch which is similar to bleeding brakes. 1) Top off the clutch master cylinder reservoir. 2) Put a clear plastic tube on the bleeder nipple and submerge the end of the tube in a jar with some clutch hydraulic fluid. 3) Slowly depress the clutch pedal. 4) SLIGHTLY loosen the bleeder nipple. 5) While fluid is traveling through the tube, tighten the bleeder BEFORE the pedal is fully depressed. 6) Release pedal. Repeat procedure until you are certain: A) No bubbles appear in the fluid stream. B) The bleeder was opened after the clutch pedal started depressing and was closed before the pedal reached the bottom. C) The master cylinder reservoir never uncovered the ports in the bottom. Make sure the slave cylinder is tightly fastened to the transmission case and does not move when the clutch pedal is depressed. Look for threaded adjustment rods in the slave cylinder and clutch pedal linkages that can be used to insure the clutch is fully released BEFORE the clutch pedal is fully depressed.
Probably on top of the slave cylinder
The bleeder is located at the clutch arm on the bell housing. There is a fluid line going from the master cylinder to the clutch bleeder. This metal line has flexible hoses at either end. Follow this line down to the front of the engine just about in the middle and you'll find the bleeder valve.
At least the slave cylinder. The clutch master cylinder can be replaced at any time.
Fill resevoir Open bleeder screw to let fluid run out depress clutch pedal to floor Close bleeder screw