right nest to header is the clutch slave cylinder it has a bleeder screw
Brake bleeder? Clutch bleeder? Coolant bleeder?
Most hydraulic clutch systems do have a bleeder valve.
Check Clutch master and slave cylinders
'99 Ford Escort ZX2: 6.5" front, 6x8" rear
Yes, there are bleeder valves for cooling systems for 99 Malibu.
In cylinder
The bleeder is located at the clutch arm on the bell housing. There is a fluid line going from the master cylinder to the clutch bleeder. This metal line has flexible hoses at either end. Follow this line down to the front of the engine just about in the middle and you'll find the bleeder valve.
where is the bleeder valve for 2003 Saturn ion clutch
Concentric slave cylinder mounting-1996-99 vehicles equipped with the New Venture Gear transmission.Its mounted in your transmission,but the bleeder screw is assible because theres a hole in transmission,where bleeder is,just put wrench on and loosen,have someone one push clutch pedal to floor and hold,then open valve,do this till air is gone,theres another hole next to hole where bleeder screw is,a metal tube comes out of that one,its the clutch fluid line,good luck.
Look at the back of the engine where the slave is for the clutch. The bleeder is right there. Just follow the hyd. line on the right side.
Same as for the brakes. Locate the bleeder, slack it and re tighten. Have someone pull in the clutch and hold, you release the bleeder, then tighten it while the clutch is still held in. Once the bleeder is tight, release the clutch and repeat till all the air is out. Make sure to refill the fluid.
I'm having a hard time finding the bleeder screw for my clutch on a 96 Chevy Cavalier 2.2? Can you help?