The clutch gets its fluid from the master brake cylinder reservoir. The master clutch cylinder sits just below the master brake cylinder reservoir and is fed fluid by gravity.
The clutch reservoir on a 1995 Toyota will be found on the slave master cylinder. These are located on the firewall of the engine bay.
The clutch master cylinder is fed through a hose from the brake master cylinder reservoir. It is located on the firewall under the hood directly in front of the steering wheel, under the wiper motor.
Drivers side, near the brake master cylinder, Look for a cap that screws on.
Clutch master cylinder reservoir.
The clutch master cylinder gets it's fluid from the master brake cylinder reservoir. The clutch is below the brake and gets it's fluid by gravity. If you need fluid just add to the brake reservoir.
The clutch master cylinder is supplied from the brake fluid reservoir via a rubber tube.
The brake fluid for the entire system is added in the master cylinder container. The slave cylinder does not have its own reservoir.
Right at the clutch master cylinder reservoir under the hood.
The clutch fluid reservoir is located on the firewall close to the brake master cylinder. You can visually see the level unless the reservoir is to dirty.
If you allowed the master/reservoir to drain empty while the line was disconnected or installed the master dry, you may have to remove the master and bench bleed it first. Always keep the reservoir full during the process.
The clutch master cylinder and the brake master cylinder are part of the same system . Both can be filled at the brake master cylinder using brake fluid