answersLogoWhite
Computers
Auto Parts and Repairs
Oldsmobile Intrigue

Where is the computer in a 1998 Olds Intrigue?

444546

Top Answer
User Avatar
Wiki User
2005-09-30 15:55:09
2005-09-30 15:55:09

In the right kick panel. On my 98 Intrigue it's it the engine compartment in the black box connected to the air filter.

1

Related Questions

User Avatar

Change what?Change what?

User Avatar

What does 'service engine soon' light mean on a 1998 olds intrigue?

User Avatar

Most parts on the 1998 through 2002 Olds Intrigues are interchangeable.

User Avatar

On the 99 Olds Intrigue, the camshaft sensor is located on the rear of the engine. It is just above the starter.

User Avatar

I do not know specifically for your vehicle, however I had the same thing on my 1998 Olds Intrigue. The mechanic turned the key to the on position, then pressed down on the accelerator three times. That reset my sensor.

User Avatar

Need to ask a complete question please. Yes, 98 olds should come with a driver's window.

User Avatar

The camshaft sensor on the 99 Olds Intrigue is located on the engine block. It is under the starter, which has to be removed to locate the camshaft sensor.

User Avatar

The firing order for an Olds Intrigue is 1-6-5-4-3-2. The number one cylinder is on the drivers side, closest to the firewall.

User Avatar

Should be able to access under hood at center firewall plastic panel may have to be removed

User Avatar

Need clarification on what you are asking.

User Avatar

To repair the power window on the 1998 Old Intrigue, you will first need to remove the interior door panel to access the window motor, switch, and actuator. You can then determine which part is broken or damaged and replace that part.

User Avatar

Under the glove box and air bag. Remove the airbag fuse and disconnect the battery before attempting to remove the blower motor.

User Avatar

what is a 1998 olds moblie cutlass value

User Avatar

The 1999 Olds Intrigue does have a dipstick. Use a funnel to add fluid as needed into the dipstick tube.

User Avatar

The 1998 Oldsmobile Intrigue throttle position sensor is held in place with two retaining screws. Remove the retaining screws and the wiring harness. Reverse the process to install the new throttle position sensor.

User Avatar

there is none. the speed sensor is in the tranny


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.