There is not a cooling fan sensor, as in a separate coolant switch that is used to turn on the cooling fan. The PCM turns on the fan through a relay. The PCM looks at ECT information for engine control information like fuel adjustments and cooling fan operation. The ECT on a 2.0 liter is on the rear of the engine, upper area, toward the front of the car. On a 2.5 liter it is on the rear of the valley area of the engine.
Its located on the bottom of the coolant reservore.
You can uninstall thermostat and install new thermost under air filter and look coolant hose by sensor gang. I did my own car.
The ECT or the Engine Coolant Temperature Sensor is a switch. This switch is located on the bottom of the radiator in the 1996 Camry.
Should be at the lower section of the coolant recovery tank
Coolant Temperature Sensor/Switch (For Computer) ECCS Component Parts Location
check/replace the engine coolant level sensor located in the engine coolant overflow reservior (located at the rear of the engine compartment pass. side)
How do you add freon to a 96 Ford Contour
It should be located in the recovery tank.
next to the thermostat housing.
the sensor on 96 V10 motor is in front on top behind air con
Answerits the coolant level sensor, located on the passenger side of the radiator.the sensors are known to go bad over time.the engine coolant temp sensor is located on the drivers side head, and will have 2 wires on 99+ and 3 wires on a 1998 ls1 f-carActually, coolant temperature module / sensor is located on the water pump of your '96 Z28. Changed my last year - fairly easy to do.
The sensor is threaded into the coolant passage in the back of the cylinder head.