what is the oxygen sensor location on a 1993 oldsmobile cutlass ciera 3.3l v6
where is the knock sensor located on 93 cutlass ciera
where is the crankshaft sensor located on a 1988 cutlass supreme
The 1994 Oldsmobile Cutlass cam sensor is located on the back of the left cylinder head. The cam sensor should be labeled as such.
where is the crank sensor located at on a 1996 cutlass ciera wit a 3.1 engine
it is located under the coils and ignition modual it is mounted under it all, it comes out with the modual, and be careful if it has been there a while you may break it,
Check the coolant temp sensor, or just replace it if you have the money to burn.
Where is the choke sensor on a 1991 Oldsmobile ciera 3.3L
The oxygen sensor on the 1999 Oldsmobile Cutlass Sierra is located on the lower exhaust. If you need to replace it, they are available for about $20 online.
changing the crankshaft sensor
Don't know for sure but check in the radiator overflow. Tip: The radiator can be full but if the overflow is low or empty it will trigger the light.
On the 3.8 it is located in between the alternator and distributer. If you follow the hose to your thermastat its below that kinda hidden but there are 2wires connected to it..
The 1984 Cutlass is a model of car produced by the company Oldsmobile. The oxygen sensor is typically located near or on the engine block.
Either your coolant is actually low or you have a coolant sensor bad.
The starter on a 1994 Oldsmobile Cutlass Ciera is located on the driver's side of the engine towards the bottom of the engine. It is behind the crankshaft sensor and the fusible links.
It should Be located on the top of the transmission.
Nee more info cutlass supreme or cutlass ceira which engine 3.1-- 3.8-- 3.3-- ????? Oldsmobile cutlass ceira 3.3 liteer engine
Fire wall side of the engine, just before the transmission.
Usually in your rectum. Depends on how deep you like it?
Remove the oxygen sensor vacuum to. Remove the oxygen sensor screws. Reverse the process to install the new oxygen sensor.
If it is a quad 4, the knock sensor is on the firewall side of the engine, at the transmission end of the engine, just below the exhaust manifold. It has a single lead and is about 2" in diameter and 1-1/2" high. Use a proper fitting socket or wrench to unscrew it.
It takes a special gauge to install the crank sensor. It can be rented from some parts stores.
Try changing the fuel filter and the map sensor.
It should reset itself when the coolant is back to the appropriate level as long as the sensor is working properly. If you look in the overflow reservoir and can see coolant, the sensor or wiring might be the problem.