it is on the top side of the bell housing on the drivers side
Top driver side of the bell housing.
Possibly caused by a bad Crank Position Sensor. Could also be the cam position sensor or the coil. They all work together.
No, there is no fuse for the crank sensor
The cam position sensor is inside the distributor, under the rotor. The crank position sensor is through the top of the bell housing, behind the passenger side cylinder head, under the transmission tube.The cam position sensor is inside the distributor, under the rotor. The crank position sensor is through the top of the bell housing, behind the passenger side cylinder head, under the transmission tube.
The crank shaft position sensor is just above the oil filter at the tail end of the starter
It is located on the bell housing on the driver's side of the vehicle.
Where is the crank position sensor hole on a 2003 Blazer
No, the throttle position sensor detects how far open the intake is. The crank position sensor watches the rotation of the crankshaft.
it does not have a crank position sensor. it uses the ignition control module as a crank sensor. it is in the distributor cap
The crank position sensor is on the front of the engine. It is behind the crank pulley on the left side.
Crank no start.
The crank shaft position sensor should be located next to or In behind the timing belt dust cover. You may have to remove the harmonic balancer pulley to reach them.