answersLogoWhite

0


Best Answer

the crank sensor is located in the transmission bellhousing on the lower passenger side where the trans bolts to the engine almost right above the right axle shaft. one 10 mm bolt holds the sensor in place, this is on the 3.5 liter engine,

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the crank sensor located in the 1996 Chrysler LHS?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the crank sensor on a 1994 Chrysler 3.3?

where is the crank positioning sensor on a 1996 newyorker van


Can the oxygen sensor cause your car to not crank on a 1996 Chrysler Concorde?

No.


Would the crank shaft sensor stop the 1996 Chrysler van from turning over?

No.


Where is the crank sensor on a 1996 Chrysler Sebring 2.5?

It is on the top rear of the transmission bell housing.


On a 1996 Chrysler sebring 2.5 V6 what is at the receiving end of the crank position sensor does it get its signal from the crank shaft itself or is something attached to the crank?

There is a tone wheel on the crank/flywheel that the sensor reads off of, if that is your question.


Where is the camshaft position sensor and the crankshaft sensor located on a 1996 olds bravada?

It is located on the distributor under the cap and rotor Crank sensor should be on the front bottom of engine by the crank pulley


Where is the crank sensor on a 1996 Chrysler New Yorker?

It is in the passenger side of the bell housing, just behind the engine.


What are the symptoms when a crank sensor is bad in a 1996 Chrysler Sebring?

The most common would be engine cranks but does not start.


Where is 1996 Oldsmobile Cutlass Supreme Position Sensor Location?

where is the crank sensor located at on a 1996 cutlass ciera wit a 3.1 engine


Where is crankshaft position sensor located in a 1996 accord?

by what i understand its located between the crank pully and block.


Where is a crank sensor located for a chrysler sebring 1996 2.5?

It is on the top rear of the transmission bell housing.It is on the top rear of the transmission bell housing.


Where is the crank sensor located on a 1996 Concorde?

the crank sensor is located in the transmission bellhousing on the lower passenger side where the trans bolts to the engine almost right above the right axle shaft.