Car Fuses and Wiring
Crankshaft Sensors
Chevy Blazer S-10
1982-1994 Chevy Cavaliers

Where is the crank sensor on a 1991 2.2L cavalier?

131415

Top Answer
User Avatar
Wiki User
Answered
2009-02-16 20:46:52
2009-02-16 20:46:52

Below the Coil Assemblies (where the plug wires go). You can only see it from under the vehicle. Don't confuse with the vehicle speed sensor. The Crank Sensor wire harness (2 wires) plugs into the Direct Ignition System module (behind the coils)

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


it is next to the coils at the rear of the engin between the tranmission and the engin

its the sensor in the tube going in to the throttle body from the air cleaner

22L (liters) is 5.81 US gallons.

The thermostat is on the water pump.(the left side in the front of the car) 2 screws to take out that's all

97 chev cav fuel filter is located in under rear passenger side right by the wheel axle.

turn the bulb clockwise until it pops out unclip it put in new one and twist it back in tadaaaaa!

looking at the rear of the motor from under the car from left to right 1/3 2/4

with the rocker cover removed, try pushing down on the pushrod end of the rocker arm. if it moves ,the lifter is bad

lr stands for long rifle(uses a bullet) I dont know where you got 22l from

the t.p.s is right across from the throttle cable on the throttle body the when u find it u will see how to take it off

there is a sensor in the bottom of the coolant bottle, change this and you should be o.k. tap the sensor with a screw driver it will go out uts just stuck

your eng has jump timeing Or you may need to replace the cam position sensor

That is 6.063 US gallons.

10-1000 USD depending on specifics.

Impossible to answer without more information

My 97 cavalier 2.2L engine takes 4 quarts. There are two different 2.2 Chevy motors. One holds about 4 qts. and one holds about 5qts. Always check after filling and circulating the oil.

Impossible to answer without knowing the model.

48 foot pounds start from the center and work your way out. then go back over them and tighten them an additional 1/4 turn. remember you have to use new headbolts each time you remove the head

It may not feed well, and will not operate a semi-auto.

Please include the model number to get the correct answer to your question.

As much as 350.00 us , depending on the overall condition of course.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.