0
It is on the lower right hand side of the bottom part of the timing cover, with a wire that leads up towards the alternator with a quick disconnect clip. You can use this wire to check the ohms on the sensor before you start the job of replacement.
you must remove both top and bottom timing belt covers to replace the sensor which means pulling the top torque motor mount and the crank shaft pulley, I recommend that I you are going to go this far on the 2.2 motor, I suggest that you replace the timing belt, oil pump seal and front main crank shaft seal while you are in there a new belt is around 40 bucks and the seal kit "TCS 45920" is about 15 bucks and to have a shop do it is about 450-500 bucks there are may YouTube videos you can watch on how to do it but make sure you get a book on the procedure to check your work, any shop will tell you they have to bill for 6 hours, I did the job in 3 and I have never done this job before. its not that hard if you do your homework
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How do you replace 92 Toyota Camry power steering pump?
94 toyota camry
How do you replace turn sinal flasher 92 Toyota Camry?
how to replace the turning flasher on a 92 camry
Wheres located the ecu in a toyota camry 92?
The ECU in a Toyota Camry is located underneath the dashboard.
Where is the crankshaft position sensor on 92 Toyota?
the 92 4afe toyota engine does not have a crankshaft position sensor
Where is the crank angle sensor on a 92 eclipse?
the cam angle sensor is the crank angle sensor it preforms both jobs
You put a new crank sensor in your 92 Buick and now its like its out of time?
You put a new crank sensor in your 92 buick and now its like its out of time?
How do you locate the fusible links Toyota?
how do you locate the fusible links in 92 Toyota Camry
Does a 1996 Toyota Camry have front end struts or shocks?
I have a 92 Toyota Camry (same model as yours) and they have struts on all four.
If a 92 Jeep Cherokee will crank over but will not start what is the problem?
probably crank sensor, they are famous for that
Where is the crank sensor on a 92 150 dodge truck 318?
The "crank" sensor is the pickup plate under the distributor cap.The "crank" sensor is the pickup plate under the distributor cap.
Will 92 park avenue start with bad cam sensor?
No it will not start need to change the cam sensor & crank sensor!
What size is the rear freeze plug on a 92 Toyota Camry LE?
Its 35 mm
