Top pass side of the bell housing. Look behind the pass side cylinder head.
The crank position sensor is mounted on transmission bell housing in the front.
check on the back of the motor above the transmission
The crank or speed position sensor on a Volvo S60 is on the engine where the engine attaches to the transmission. It is in the 12 'o clock position and is normally blocked by the bootom radiator pipe which goes over the transmission. Vinesh vinvyt@gmail.com
The cam position sensor is inside the distributor, under the rotor. The crank position sensor is through the top of the bell housing, behind the passenger side cylinder head, under the transmission tube.The cam position sensor is inside the distributor, under the rotor. The crank position sensor is through the top of the bell housing, behind the passenger side cylinder head, under the transmission tube.
The crankshaft position sensor is on the top rear of the transmission bell housing.
The crankshaft position sensor is at the rear of the engine where it joins with the transmission bellhousing. It is at the left (front) side, not far from the starter.
Where is the crank position sensor hole on a 2003 Blazer
It is on the passenger side of the transmission bell housing.
No, the throttle position sensor detects how far open the intake is. The crank position sensor watches the rotation of the crankshaft.
it does not have a crank position sensor. it uses the ignition control module as a crank sensor. it is in the distributor cap
The crankshaft position sensor is located on the top of the transmission. It is located close to the bell housing.
The crank position sensor is on the front of the engine. It is behind the crank pulley on the left side.