Want this question answered?
The crankshaft position sensor is located on the top of the transmission. It is located close to the bell housing.
It's on the passenger side of the bellhousing.
The camshaft sensor is located on the drivers side top of engine at the end of the valve cover.
try crank position sensor and cam shaft sensor
It is in the side of the block behind the starter.
It is a magnet that puts your engine back in the correct position once you turn your vehicle off so it will starrt again,I've had this problem twice..
most crank sensors are for engine timing with the cam shaft, the distributor on at least 97' dodge and newer controls fuel timing.
No, just the distributor pick up plate (cam sensor)
Where is the crank shaft sensor located in a Audi a6
Check the link for locations of crankshaft sensor on 2.0, 2.4 and 2.5l engines. http://www.autozone.com/addVehicleId,2340402/initialAction,repairGuide/shopping/repairGuide.htm?pageId=0900c1528008987d
A bad cam or crank sensor can cause a no start, but the engine will still crank or turn over.
Check your Idle Air Control Motor located underneath the Throttle position sensor.