It should be above the starter on the engine block.
The crankshaft position sensor on a 1987 Chevrolet Celebrity is on the side of the engine nearest the firewall. I need to know which engine to give a more specific answer.
the back
The crankshaft position sensor is located on the lower engine block beneath the exhaust manifold on the firewall side of the engine.
Crankshaft position sensor circuit malfunction.
The 1999 Chevy Lumina 3.1 liter engine crankshaft position sensor is located on the back of the crankshaft. A diagram can be obtained from most Chevrolet dealerships.
On the 2.8 V6 engine the crankshaft position sensor is near the bottom center of the block on the side nearest the firewall. On the 2.5L 4 cylinder engine the crankshaft position sensor is behind the ignition module below the intake manifold.
It is at the front of the engine, below and to the left of the damper.
The 1995 Mitsubishi Eclipse crankshaft position sensor is located on the back of the engine. The crankshaft position sensor will be near the bottom of the engine cover.
is the crankshaft position sensor the same and the engine speed sensor
The crankshaft position sensor measures the rotational position of the crankshaft for the engine computer. That info is required for fuel and ignition timing.The crankshaft position sensor measures the rotational position of the crankshaft for the engine computer. That info is required for fuel and ignition timing.
the 92 4afe toyota engine does not have a crankshaft position sensor
The location of the crankshaft position sensor depends on which engine your car has. If it is the V6 the crankshaft position sensor is on the side of the engine block next to the firewall. It is low on the block in about the center of the block. It is held in by a single bolt. The knock sensor is also back there but is screwed into the block with pipe threads On the four cylinder engine the crankshaft position sensor is behind the ignition control module which is below the intake manifold toward the rear of the engine. You can follow the spark plug wires to it. Changing it is a real nuisance but can be done with the engine in the car.