0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you connect the radio antenna on a 1993 Ford f150?
To connect the radio antenna on a 1993 Ford F-150, the back of the radio needs to be exposed under the dash. Plug the radio antenna wire into the back of the radio and tighten the nut.
How do you disconnect the radio antenna on a 1999 Oldsmobile intrigue?
Disconnect from the radio by unplugging it from the back of the receiver. It has a standard radio plug.
How do you replace the antenna on a 2000 Ford Ranger?
first pull out the radio and undo the antenna plug from the back of it. Tie a 6 foot peice of bailer twine or similar string to the end above the plug, and tape it on. Next undo the screws in the plate holding the antenna to the fender of the truck( if that is the type you have). Pull the antenna wire out until you get about 6 inches of the string. Tie the string to the plug on the new antenna and tape it on. Go back into the cab and pull the string until you can get the plug. Pull the plug until you can plug it into the radio. Reinstall the radio. Go back to the fender and feed the rest of the antenna wire into the hole and put the screws back through the plate to hold the new antenna in place. If it doesn't have screws and plate, then the antenna is held on by a nut under the fender, and you need to undo the wheel well liner to get at it. good luck.
How do you reset the radio of an Acura TL 2000 when it won't accept the security code?
What worked for me was to unplug the antenna in the back of the radio and then enter the security code. Once the security code is entered, you can plug the antenna connector back into the radio.
How do you replace the antenna on the 1992 Toyota Paseo?
1. Remove radio 2. Unplug antenna cord (usually on the left of the radio as you are facing the radio) from the back of the radio. 3. Thread antenna cord by gradually pulling it through to where a hole is located down and in front of the driver's side car door(this is where the antenna cord comes down from windshield/window column). 4. Tie about four feet of a strong line or string to the end of the antenna cord plug (this will help when threading in the new antenna cord). 5. Unscrew the two screws holding the antenna assembly near the roof on the windshield/window column. 6. Carefully pull the antenna assembly up from the windshield/window column at the same angle as the column. Do this until the end of the antenna cord, with the string attached to the plug, is visible. 7. Untie the string or cord from the old plug and tie it on to the plug of the new antenna cord. 8. Carefully pull the attached string or cord from the hole located down and in front of the driver's side car door. At the same time make sure the cord is being fed through the hole where the antenna assembly fits. Keep pulling on the new cord until its plug appears at the hole located down and in front of the driver's side car door. Pull the new cord out through the hole eliminating all of the slack in the new cord. 9. Repeat steps 1 through 5, but in reverse order. Added: Excellent advice was given above. I was able to replace the antenna on my '92 Paseo. One word of advice: You may have trouble pulling up the antenna assembly up from the windshield/window column. This is because there are two clips located underneath the steering wheel assembly that are holding the antenna cable in place. I found this by accident when I was following the antenna cable starting from the end ( that plugs into radio) along underneath the steering column.
How can you disconnect a power antenna on a 1987 Trans Am without taking the fender off?
Cut the electrical connection or remove the plug behind the radio. Buy a new antenna at Radio Shack. Remove inner fender (plastic) for access to antennna.
How do you check the connection from radio to antenna on a Isuzu Rodeo 2001?
A simple continuity test will do, check for continuity from the antenna to the plug. Not much goes wrong with these though I would look at the plug connection at the back of the stereo sometimes they are loose and come apart.
How do you hookup a radio in a 94 jeep Cherokee?
try this..................... The molding around your radio pops off, you may need to pry in the cornors. take out the 4 screws that hold in the radio, pull out radio disconnect the antenna, power, than plug back in the new one, replace molding. The molding around your radio pops off, you may need to pry in the cornors. take out the 4 screws that hold in the radio, pull out radio disconnect the antenna, power, than plug back in the new one, replace molding.
Where is the power antenna relay on a 95 Toyota 4Runner?
The power antenna relay on my '91 4runner is located almost directly above the clutch pedal. It is a black box about 3"x4"x1" and has a white plug coming out of the front of it. The easiest way to pinpoint it is to turn the volume on your radio all the way down, and just turn the radio on and off. Follow the clicking till you have it.
Where is radio antenna plug on 1996-2005 Ford Taurus - Mercury Sable?
I have a '99 Taurus. There doesn't seem to be an antenna plug near the dash. The only one I have found is near the antenna itself in the left rear fender well. you will have to go buy a antenna adapter... its a long wire that will plug into the back of the anatenna and then run it through you back seat and then under your bottom trim to the center control center if you have any Q's email me at CobraJet_07@yahoo.com. i just put a new CD player in my 1998 Ford Taurus and i have a lot of good tips for people I'm not sure about the Taurus wagon, but I had to replace the antenna on a Mercury Sable wagon. The radio module is located in the left rear trunk space behind the wall trim. You will have to remove the module to replace the antenna wire. Hope this helps.
Will window tint cause the radio to static on a 2002 Honda civic lx?
No it will not. Your radio antenna is the top portion of the rear window. unless you cut it somehow.. It is also possible that the antenna booster located on the left side of the back window behind the pillar molding was bumped when tinted and that could cause the static. I had this problem once with a Civic Coupe. pull the cover on the pillar and unplug the antenna wire and the plug it back in. If you have not had the problem fixed try that.
Where is the transmission drain plug on an 1993 crown Victoria?
the transmission drain plug is located on the transmission underneath the dash area
