If memory serves, it should be under the hood either near the right hand side of the firewall, but I might be wrong and it's under the hood near the left fender close to the battery. It should have a black plastic cover which may be labeled 'EEC-TEST'. Not that you cannot use a generic OBDII scan tool, you will need one of the following: NGS scan tool, aftermarket scan tool with US Domestic support, or a multimeter and jumper wire. The multimeter and jumper wire will retrieve codes but not read the data stream as a scan tool will.
The diagnostic port on a 94 Ford Taurus is located under the hood near the firewall usually on the driver's side. Ford started producing the Taurus in 1985.
On a 1994 Ford Taurus : firewall 1-----2-----3 4-----5-----6 front of vehicle > driver
Master cylinder located at the driver's side firewall
The 3.0 and the 3.8 liter V6 engines in a 1994 Ford Taurus are fuel injected , so there is no carburetor
where is the transmission speed sensor located on a 2005 ford taurus
no,the 96 is electronically controlled,the other trans is not
The price of a fuel filter on a 1994 Ford Taurus
In a 1994 Ford Taurus : Both the 3.0 and 3.8 litre V6 engines have a timing CHAIN
2002 ford taurus where is the orifice tube located
It is located on top and inside the fuel tank. You must drop the tank to replace it.
I have a 1998 Ford Taurus with the check engine light on, i received a diagnostic code of 7441, which they indicated i needed transmission fluid, but when i checked in park,hot and idling it indicated full..how should i address this code
On a 1994 Ford Taurus , V6 : firewall 1-----2-----3 4-----5-----6 front of vehicle