After the catalytic converter. My GT actually has four O2 sensors, two before and two after the catalytic converters (one for each bank of cylinders).
2.0ltr its in distributer
the camshaft sensor is located in the distributor. you need to purchase the entire distibutor to replace the sensor.
"Where is the crankshaft position sensor on a 96 ford probe SE?"
I think you might mean your "IAC" sensor. If so, it is right on top the trottle body
where is the ecu located on a 97 ford probe
there are twoCrank sensors on the ford probe GT. One is located in the distributor that control spark and by taking the passenger front wheel off and to the right of the crank shaft pully you will see a one bolt device with three wires, that is your lower crank sensor.
The exhaust back pressure sensor on a 2006 6.0 diesel Ford F3 50 can be located near the exhaust manifold. The sensor is a probe that can be removed by loosening the nut.
It is located on the air filter box. Has a plug with 3 or so wires in it.
in the 3.0l models it is located right on top of the transmission. It makes a difference in sensors if you have the analog or digital cluster on the dash.
The sensor for the engine coolant on a 1991 Ford Probe LX is inside of the coolant tank. There is a lever, and when the fluid gets below this lever, it signals to be checked. It should be refilled.
where is the map sensor located on a ford freestar
On the Ford Probe 93-97 GT's the knock sensor is located underneath the intake manifold. More specifically it is threaded into a fitting on the deck of the engine block in between the heads in the Valley. Shouldn't be too bad if your an experienced mechanic or a mechanically inclined individual. Hope this helps ya out, and good luck.