0
On a 1996 Ford Explorer , 4.0 liter OHV , V6 engine :
The DPFE is on the drivers side of the engine , on the drivers side of the
" plastic " upper intake manifold . It is rectangular shaped , about 3 inches
long , 1 and 3/4 inches wide , and 3/4 of an inch thick , with an electrical
connector plugged in to the front and 2 small diameter hoses connected to
the bottom . The originals and old replacements were metal but the newer
replacements are plastic .
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Where is the map sensor on 1996 ford explorer 5.0?
The MAP sensor on a 1996 Ford Explorer 5.0 is located on top of the engine near the throttle body. It is bolted to the engine and also has a wiring harness attached to it.
Where is the knock sensor located on a 1994 Explorer sport 4.0?
Ford did not start using knock sensors on the Ford Explorer engines until 1996, when they switched to the EEC-V system.
Where is the location of tensioner 1996 Ford Explorer V6?
Where is the tensioner located on a 1996 Ford Explorer V6 XLT?
Where is a ford overdrive sensor on a 96 explorer?
The 1996 Ford Explorer overdrive sensor can be found on the right hand side of the transmission. The overdrive sensor will be near the front of the transmission.
Where is fuel rail pressure sensor located on 2000 Ford Explorer 4.0 v6?
where is fuel rail pressure sensor on 2000 ford explorer 4.0 located?
Where is the cam sensor located on a 1996 Ford Explorer 4.0?
On a 1996 Ford Explorer : 4.0 litre EFI , V6 engine : From what I have read the camshaft position sensor is on top of the engine , about the center line , at the rear of the engine near the firewall You can't see it with the " plastic " intake manifold installed
Where is the air charge temperature sensor located on a 1996 Ford Explorer?
On my 1995 Ford Explorer - 4.0 L - OHV - V6 , the intake air temperature sensor is in the big rubber air intake tube , facing to the rear , near the throttle body . A 1996 - V6 - should be the same
Where is the mass air flow - MAF - sensor relay located on 1992 Ford Explorer?
The Mass Air Flow sensor is located on top of the air filter housing on Ford Explorer.
Where is the IAT sensor located on a 1998 Ford Explorer 5.0L?
The 1998 Ford Explorer 5.0 liter engine IAT sensor is located between the engine and the air filter box. The IAT sensor will be on the air intake hose.
Where is the power distribution box on a 1996 Ford Explorer?
On a 1996 Ford Explorer : The power distribution box is located in the engine compartment , on the drivers side
Where is the bank 2 sensor 2 oxygen sensor located on a 2001 Ford Explorer sport?
Bank 2 is the drivers side of the engine in your Ford Explorer Sensor 2 is after the catalytic converter ( downstream )
Where is the transmission housing sensor located on a 1993 ford explorer?
i don't know the answer
