0
On the intake tube below the mass air flow sensor. Part # 90910-12259
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is the erg valve located on a Ford F-350 super duty?
This might depend on the year, but mine is located on the drivers side of the throttle body.
Where is the icp sensor on 2005 f350 6.0 diesel super duty located?
The icp sensor on an 05 powerstroke is on the passenger side valve cover towards the front of the engine
What is the most heavy duty vacuum available?
The Dyson Animal DC25 Ball Lightweight Upright Vacuum Cleaner really is the best.
Where is the abs control unit located for a 2002 ford expedition equipped with 4 wheel anti-lock brakes?
The valve is located on the frame rail, under the vehicle on the driver's side on the 1997-98 F-250HD F-350 and F-Super Duty. The valve is located in the brake lines, below the master cylinder. 1. Disconnect the brake lines from the valve and plug the lines. 2. Disconnect the wiring hardness at the valve. 3. Remove the 3 nuts retaining the valve to the frame rail and lift out the valve. 4. Installation is the reverse of removal. Don't overnighter the brake lines. Bleed the brakes.
What is a triple duty valve and what are its advantages and disadvantages?
Triple duty valves combine the features of a check valve, a throttling valve, and a shut-off valve, and are designed for installation on the discharge side of centrifugal pumps. The convertible body design allows the triple duty valve to be changed on-site from a straight configuration to an elbow configuration. They prevent the end user from having to purchase many different types of valves separately, this saves money in materials and uses limited floor spacing.
Where is a vacuum line on 2003 Chevy Silverado 2500HD?
Vacuum lines on the 2003 Chevy Silverado 2500 heavy duty pickup truck. A diagram of the entire vacuum line system can be obtained from most Chevrolet dealerships.
What causes ABS light to come on in a 2000 Lincoln Navigator?
AnswerReplace the speed scensor on the rear differential. It is about a $20 switch._______________________________________________Check related link below for more information... _____________________________ ABS Control Valve The valve is located on the frame rail, under the vehicle on the driver's side on the 1997-98 F-250HD F-350 and F-Super Duty. The valve is located in the brake lines, below the master cylinder.1. Disconnect the brake lines from the valve and plug the lines.2. Disconnect the wiring hardness at the valve.3. Remove the 3 nuts retaining the valve to the frame rail and lift out the valve.4. Installation is the reverse of removal. Don't overnighter the brake lines.Bleed the brakes.
What are variable valve actuators?
Dear Sir,does it mean "modulating duty",it means can control the valve by a singal. for more informaion,can refer to http://www.valve-actuator.org/Multi-turn-Valve-Actuator/118.html
How do the expansion valve perform its duty on 1994 Toyota Camry?
It meters liquid high pressure refrigerant into the evaporator which is located in the heater housing under the dash. It controls refrigerant flow to keep the evaporator coil from icing up.
Does a 2001 F-350 Super Duty have an IOD fuse and if so were is it located?
Does a 2000good f-350 super duty have an iod fuse and if so were is it located
Where is the Location of duty cycle purge valve on 2003 Jeep Liberty?
It is under the hood, next to the battery.
How do you bypass the vacuum on the front actuator?
This sounds like a YJ jeep issue, I eliminated the vacuum actuator by installing a heavy duty choke style manual cable attached to the vacuum actuator arm, that way I can lock the front diff when I wanted. Make sure you cap off the vacuum line, otherwise your engine will run poorly.
