On the rear of the engine block next to the firewall about 1/2 way down. You can see the 10mm bolts from above, (at least the top one), and access them with your left hand using either a 1/4" drive, or box end wrench.
The lower bolt is 1 1/2" directly below the top one. Remember to buy the gasket in advance.
After unbolting the EGR valve, if you are re-using it, make sure all of the old gasket material is off of the mating surface. I used emery cloth held onto a piece of wood, and just rubbed the valve across it until the gasket material was gone.
I like the metal gasket for a $couple more online.
JZ
were is the egr valve located on a 1998 infiniti i30
where is egr valve on 1998 ford contour
in the back, behind the engine
according to the emissions label it does not have an EGR valve.
The 1998 Ram does not have EGR.
A 1998 Jeep Wrangler does not have EGR.
A 1998 Dodge Ram does not have EGR.
The EGR valve on a 1998 Suzuki Sidekick is not repairable. It has no replaceable or user serviceable pieces or parts.
On a 1998 Ford Explorer, the EGR valve is located on the intake manifold. It is behind the throttle body.
It doesn't have an EGR.
The EGR valve is bolted to the rear cylinder head at the transaxle end
The EGR valve on a 2001 V6 Tracker in on the center rear of the intake manifold plenum chamber, on the underside. You will see a tube from the right bank (bank 1) Catalyst going up and to the intake.