answersLogoWhite

0


Best Answer

The EGR valve is hidden under the air filter box. It lies on top of the intake manifold, just in front of the throttle body. It will have a vacuum line leading to the T.B. as well. Test it by sucking on it's hose and feeling under the round dome. The valve should move, and not return until you let air back in.

User Avatar

Wiki User

19y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the egr valve on a 92 Pontiac Lemans 1.6 ltr?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Art & Architecture

How many quarts of oil are needed in a1.6 ltr 4-cylinder AT 1991 Honda Civic?

4


What Wood stain or paint is suitable for railway sleepers in great Britain?

i used sikkens HLS Plus: Light Oak after testing several other products (Cuprinol, Ronseal etc) i even used Deck Stain, wood dyes etc on the test areas but chose sikkens as it looked the best and was a low build solvent based penetrating pre-stain which meant it soaked deep into the wood but was translucent enough to still see the grain..... after lots of sanding with a electric hand sander Light Oak dried more like Dark Oak on rough timber but after 2 coats it looks great so beware not to choose a colour too dark like walnut as it will look black..... The downside is the cost £58 for 5ltr, £33 for 2.5ltr £14 for 1ltr..... i needed 6 ltr for the first coat and 4 ltr for the second to stain 50 sleepers... but the finish i got out weighed the cost as you don't want to mess your hard work up at the last hurdle by choosing the wrong stain... whatever brand you choose make sure it is a low build stain as medium to high build smother the grain and have a satin finish which doesn't look right


You have your car flooding its a spirit wita 2.5 ltr engine and it has a throttle body carb on it but it just keeps pumping gas into the carb what could cause this prob?

So which is it? Carb or Throttle Body? Throttle body is a single (sometimes 2) electronic fuel injectors mounted in a carburetor LOOKING device that sits on the intake manifold. A flooding throttle body injector system is caused by faulty electrical to the injector or more likely a sticking injector. If the problem isn't too severe yet, use some injector cleaner before you spend a lot of money. If it's a CARBURETOR, you have a sticking needle & seat or a damaged float inside the float bowl. It's a relatively simple job to rebuild the carburetor but if you have never done it before, you might want to just replace your carb with a rebuilt one.


What is the world's fastest four wheeler?

As fast as is safe. Some people routinely race their trucks. If your question is about driving in poor conditions, do remember that four wheel drive can cause problems that your brakes can't avoid. It's much faster to get where you are doing without an accident than it is with one.


What is the spark plug gap for a 1990 2.2 ltr cavalier?

Four Cylinder 2.5Liter Jeep engine Specs - Technicals---- Displacement 150 cubicinchesCylinder numbers (frontto rear)1-2-3-4 Firing order 1-3-4-2 Spark Plug gap 0.033 to 0.038 Ignition timing 9 to 11 degrees Idle speed(auto) 600 +/- 70 rpm(manual)680 +/- 70 rpm Engine oil API SE of SF - Oil capacity 4qts Automatic TransmissionFluidMercon ATF - ATF Capacity 4qts

Related questions

Where is the EGR valve located on a 3.8 ltr 1998 Chrysler Town and Country?

Look under and behind the throttle body.


Where is the Egr located in a 1998 Ford Ranger?

My Ford Ranger is a 1998 4.0 ltr V6.


Where is the PCV valve located in 18 ltr engine 1994 VW Golf?

on top of the valve cover


What is the valve clearance on a suzuki ltr 450?

.004in intake. 008in exhaust


Where is the PCV valve located on a Chrysler 300 2.7 ltr engine?

passenger side valve cover under the intake plenum


Where is the crankshaft sensor located on a 1993 Pontiac Sunbird?

behind timing cover on front of engine if its a 2.0 ltr ohc


Where is ERG valve located on 1994 Lincoln mark viii 4.6 ltr?

In back of the engine on the drivers side.


How do you change the PCV valve on a 1989 Olds 3.8 ltr engine?

Remove the vacuum hose from your 1989 Oldsmobile 3.8 liter engine PCV valve. Remove the retaining bolts from the valve. Reverse the process to install the new PCV valve.


Where is the fuel filter and PCV valve on a 2002 Dodge 1500 with 5.9 ltr engine located?

fuel filter is under veh in frame rail pcv is in 1 of the valve covers


How many intake and exhaust valves in a 5.2 ltr engine?

A Dodge 5.2L has one exhaust valve and one intake valve per cylinder. That would make a total of sixteen valves.


How do you get 6 ltr from a 7 ltr jar and a 4 ltr jar?

Fill 4 ltr jar State of two jars: (4, 0)Pour from 4 ltr to 7 ltr: (0, 4)Refill 4 ltr: (4, 4)Pour from 4 ltr to 7 ltr jar until it is full: (1, 7)Empty 7 ltr: (1, 0)Pour from 4 lts to 7 ltr: (0, 1)Fill 4 ltr: (4, 1)Pour from 4 ltr to 7 ltr jar: (0, 5)Fill 4 ltr: (4, 5)Pour from 4 ltr to 7 ltr jar until it is full: (2, 7)Empty 7 ltr: (2, 0)Pour from 4 lts to 7 ltr: (0, 2)Fill 4 ltr: (4, 2)Pour from 4 ltr to 7 ltr jar: (0, 6)Done.


Solution needs 6 liters of water to open gate?

Fill 7 Ltr jug from well 7 Ltr jug ->(pour into) 5 ltr jug Unplug the 5 ltr jug 7 ltr jug -> 5 ltr jug fill 7 ltr jug from the well. 7 ltr jug -> 5 ltr jug unplug the 5 ltr jug (You will have 4 lrs in the 7 ltr jug and nothing in the 5 ltr jug) 7 ltr jug -> 5 ltr jug fill the 7 ltr jug from the well 7 ltr jug -> 5 ltr jug You will have 6 ltrs of water in the 7 ltr jug which you can put on the lever to open the gate Shailesh Singh Pakuranga, Auckland