Want this question answered?
The exhaust back pressure sensor on a 2006 6.0 diesel Ford F3 50 can be located near the exhaust manifold. The sensor is a probe that can be removed by loosening the nut.
A Ford diesel diagnostic code P0470 means there is an exhaust pressure sensor malfunction. This may be caused by faulty exhaust back pressure sensor, or pressure sensor is open or shorted.
The exhaust back pressure sensor or EBP on the 04 is located by the upper radiator hose by the block. It has a 3 pin connector and accepts a 24mm socket.
the sensor is under the exhaust manifold at the rear of the engine
driver side on front of head, just follow the tube from the exhaust manifold on the drivers side and its there.
The Exhaust Back Pressure Control Valve Module is located in the front part of the Engine Compartment. It is just ahead of the Fuel Filter assembly, and behind the belt tensioner. It is powered by a three plug connecting wires harness.
The Exhaust Back Pressure Control Valve Module is located in the front part of the Engine Compartment. It is just ahead of the Fuel Filter assembly, and behind the belt tensioner. It is powered by a three plug connecting wires harness.
Where is the temperature sensor located on a 2004 duramax diesel?
Could be a diesel? If not then replace your oxygen sensor on your exhaust. A bad oxygen sensor causes the exhaust smoke to be dark in color.
The oxygen sensor is located on the exhaust manifold and is the only item on the exhaust with wires going to it.
exhaust manifold
It is located just above the oil filter (located in front of engine under exhaust manifold)