Remove the cover under the steering column, then remove the cover over the pedals. Looking at the steering column, three inches directly to the left is a bracket mounted vertically. On the other side of the bracket is a 'convenience center'. You can see the convenience center better by using a mirror. On the convenience center are three items: 1) A brown component which has a speaker which beeps when you don't fasten your seatbelt. 2) A white relay for your horn. 3) On top of the white relay is the hazard lights flasher. The signal light flasher is above the convenience center. Don't try looking for it because you can't see it, even with a mirror. To get the signal flasher out, look at the bracket located three inches to the left of the steering column. One inch from the top of the bracket is a small square hole about 3/8 inch square. Look closely and you'll see a clip is mounted in this hole. This clip is holding the signal flasher, which is connected to two wires. Wiggle this clip out of the hole with a screwdriver. Once the clip is free, you should be able pull the two wires and the flasher down and replace the flasher. Don't try to put the clip back into it's original position - just tape it somewhere under the dash.
First check the fuse. If this is ok the problem is most likely the “Flasher Unit”. The Flasher Unit is located behind the dash.
The flasher is a type of switch that regulates the turning on and off of your vehicle's turn signals and hazard signals.
In the Montero Sport , there is no relay. The flasher is located on the left dash by the junction block.
It is possible if the flasher relay is going out or has gone bad.
It COULD be a blown fuse. Check the fuse panel. It COULD by a blown flasher unit. If the fuse is OK, change the flasher.
you need a new flasher for your singal lights.
there's 2 warning and turn signals warning under the dash driver side on the passenger side of the steering column. you will have to remove two screw on a cover to get at it turning signal flasher is above the emerg brake petal on the side. both parts are the same.
Answer You might want to check your flasher relay which is under the dash.
Check the bulbs first but it can also be the flasher.
leftof steering column behind i/p
Turn signal flasher is located above the steering column, some models flasher is clipped on to the underside of dash to the left side of column
DRIVER SIDE, UNDER DASH, MOUNTED ON PASSENGER SIDE OF STEERING COLUMN Yeah it's there. Before make sure it isn't anything else,(fuse, bulb, etc.) It's not fun to get to that part.
your flasher is bad i had the same problem and replaced the flasher .it is located behind your e brake lever in dash there are 2 one emergency and one for turning the top one is turning
The PA Motor Vehicle Code, § 3334. Turning movements and required signals- says that you will use your turn signals or hand signals when you are turning or changing lanes.
how to replace the turning flasher on a 92 camry
How Turn Signals Work by Karim Nice = The Thermal Flasher = This small, cylindrical device is sometimes located in the fuse panel under the dashboard of the car. It costs about $3 in the auto parts store and works reliably for years. Copy & Paste Link below for more info, and pictures auto.howstuffworks.com/turn-signal2.htm
In the fuse box the round silver flasher.
I just had the same problem and found that my rear turn light bulb went out and the turn signals no longer worked. Check any of the turning bulbs. You may have replaced the hazerd light flasher. There are two flashers, the turn signal one is near the hazerd one under the dash.
Turn signal flashers: a. On 2001- Current TJ's, the turn signal flasher is located under the plastic cover on top of the steering column, ahead of the steering wheel. Removing the 3 Phillips head screws from the bottom (You'll see the access holes to insert the screwdriver) will allow the cover to loosen, there is a small latch on the forward edge of the cover that requires a small amount of force to release. The flasher is the black 1" square by approximately 2" long box that is on the right side, just above the Key. Remove this flasher unit by pulling it away from the steering wheel, or towards the front of the vehicle. Pay attention to the orientation of the flasher unit, the terminals will only allow it to go in one way. Take the new flasher and install it in the same manner. Test by turning on the key and cycling the turn signal switch and if the turn signals flash slower than previous, as slow as normal, then the flasher is correct. b. On pre-2001 TJ's, the flasher is located under the dash, clamped to the steering column, on the side towards the center of the jeep. To make finding it easier, remove the knee panel under the dash and its steel backup. Turn the turn signals on so that the flasher is clicking, then follow the sound and feel for the black box that is clicking. You can make replacement easier by removing it from it's metal clip. Disconnect the flasher, replace with new flasher unit. Test turn signals and stow the flasher unit back in its original mounting position. If the original mounting clip will not work with the new flasher, simply zip tie the unit into place.
possibly flasher. if that doesn't work. The problem may be the turning signal unit located in the steering column. Check to see if the license plate light is shoredt out in the step bumper. Mine did and it took out the turn signals and cruise control.
That is a good thing. You want the turn signals to work.
Their is no Possible way :) :(
There are two flasher relays under the dash in the car. One for the hazards and one for the turn signals. They are next to the fuses under the steering wheel right by the hood release On My 90 Acclaim the hazzard flasher is on the fuse block, the turn signal flasher is mounted on the air conditioning duct farther up under the dash. I found it by turning the signal on listening for the click and sticking my arm up to the elbow into the dash. It is fastened by a plastic clip onto the duct.
It is combined with the hazard flasher module