answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Where is the ford Windstar imrc control solenoid?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why might your 1998 Ford Windstar be idling rough and stalling?

You may want to check the IMRC's which control fuel flow on the intakes. These went bad on my 97.


Where is IMRC on 1999 windstar?

The actuator assembly of the IMRC system is attached to the cylinder head/intake manifold, just up of the water pump.


1996 ford windstar it failed the polution test the result was a P1517 code and no auto parts knows what this is HELP?

dtc 1517 imrc input error


Where is the IMRC actuator located the intake manifold runner control located on a 2002 Ford windstar on the engine?

It is located to the right of the serpentine belt, left of the intake manifold, directly above the water pump. It has two rods coming out of it and it electric controlled, not vacuum.


Where is the imrc on a 2002 cougar?

The intake manifold runner control (IMRC) is beneath the plastic IMRC cover, which is held on by several screws.


What is Ford escort part number f8ce-9j559-aa?

Intake manifold runner control aka imrc valve


On a 2001 cougar where would the inlet manifold runner control be located?

The IMRC is held in a metal box in front of the engine. It is covered by the plastic thing, called the IMRC cover by ford. There should be three or four bolts holding the cover on.


How do you replace the IMRC valve on a 1999 Ford Taurus?

This is the escort forum not the ford taurus.


The machine says the IMRC is stuck closed 1519 what does that mean its a 1998 SE ford contour?

I a guessing that you have a V6 Contour. The P1519, means that the Intake Manifold Runner Control(IMRC) solenoid is not moving when commanded by the PCM. The PCM knows it is not moving, becaus there is a built-in position sensor inside of the IMRC. The job of the IMRC is to shorten or lengthen the air flow passages into the intake manifold at the right times for maximum performance, by opening and closing ports inside of the intake manifold. These passages are moved by a cable attached to the IMRC that moves butterfly valves on shafts that run through the center of the intake. You can see the cable which will be attached to a lever and a shaft by looking right below the throttle body assembly on the driver's side of the engine. Follow that cable, and you will find the IMRC. It may even be bolted to the top of the front valve cover. Cances are you need a new IMRC. But you should clean the air intake manifold with carb cleaner to free up the butterfly valves I described. Sometimes what makes those IMRC assemblies fail in the first place, is heavily carboned up intake runner valves that cuse undue stress on the IMRC.


Where is the imrc located on a Ford Contour 1998?

Since you are asking, I assume you have a V6 Duratec powered contour. If this is the case, the IMRC is located just in front of the engine, underneath the IMRC cover, the plastic cover mounted to the engine with several screws and says "Duratec" on it.


Where do you locate the IMRC on 1998 Ford Taurus?

Its under the front valve vanity cover.


Where is located IMRC on 1999 Ford F-150?

on the front side of the lower manifold