answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2006-10-31 03:13:21

try going to www.autozone.com and enter your vehicle info and look for the inertia switch location.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Related Questions


I called Pontiac there is no cfuel cut off switch.


GM vehicles do not have a fuel shut off/inertia switch


Pontiac does not use an inertia fuel cut off switch.


Take out the fuel pump fuse and then start the car until it cuts off on its own. After it does cut off, the system is relieved of pressure.


The answer is no. Not unless you make one, but that needs to be done very carefully so not to cut the tank, hoses, and or wires. A very tricky job. drop the tank


Sorry, no fuel cut off. If you need to stop fuel flow, you need to unplug the wires at the fuel pump(by fuel tank) then run motor till engine stalls.


Jeep doesn't use fuel switches. The fuel system is computer controlled with relays.


a rough road can cause the fuel shut off switch to turn off



is there a emergency switch that shuts the fuel pump down


Lay out the new fuel line and cut it long. Snake it close to the old 97 Grand Prix and put it in the line holders if possible. Disconnect one end or the old line and hook the new one up. At the other end finish cutting to length and connect the new line.


It doesn't have one. The fuel system is computer controlled using relays.


Jeep doesn't use a cut off switch. The fuel system is computer controlled through relays.


Jeep doesn't use a cut off switch. The fuel system is computer controlled through relays.


Cut the wires on the old fixture and splice wires from new receptacle



Gm vehicle do not use inertia/reset switches.



on the passenger side floor board under the carpet


Jeep does not use inertia/reset switches. The fuel system is computer controlled with relays.


I believe it is located under a panel on rear right of trunk.


There is a cut-off switch on the driver's side in the trunk. It is usually lableled.


Fuel cut occurs at about 12PSI.


My 1991 Full Size Ford Bronco has the fuel cut off on the driver side. Behind the Brake Pedal look just to the left of the Brake Pedal and up. It's mounted on the firewall Just above the Carpet. Press the Red Button on the top to RESET.


Plymouth vehicles do not use inertia/cut off switches.Plymouth vehicles do not use inertia/cut off switches.



Copyright ยฉ 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.