Fuel Pumps
GMC Sierra
Ford Bronco
1995-2005 Chevy Cavaliers

Where is the fuel cut off switch located on a 1988 ford bronco?

383940

Top Answer
User Avatar
Wiki User
2005-11-16 00:58:43
2005-11-16 00:58:43

under the dash,,drivers side

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

where is fuel shut off switch for Ford Bronco eddy Bauer

User Avatar

to take the key switch out you need to press the little pin sized rod located on the bottom of the switch. once pushed in twist the switch out.

User Avatar

The 1988 Ford brake light switch does not adjust, replace it with a new one.

User Avatar

the switch you are looking for i beleave is the inertia switch.. on your bronco i beleave it is located behind the glove box

User Avatar

On the interior firewall to the left of the steering column

User Avatar

Check the passenger side foot well, upper left corner area under the carpet.

User Avatar

its located on the passager side of the truck under the dash

User Avatar

in the exhaust manifold right before the catalytic converter

User Avatar

Passenger side floor, up under dash to the right of the driveshaft hump. Inertia switch is under the carpeting. Just push button down on top of switch to reset..

User Avatar

A 1988 Ford Bronco weighs between 4300 and 4600 lbs. Weight variations depend on the make of the car and if it has been modified.

User Avatar

The only size I can find is for a 1988 Ford Bronco II Eddie Bauer: 205 75 15.

User Avatar

yes you may have to inter change a few things but they will fit

User Avatar

On a 1996 Ford Bronco : I believe the fuel pump inertia switch ( shut off switch ) is located in the front passenger footwell , behind the kick panel * the kick panel is the interior trim panel , in front of the front door , beside the passengers right foot

User Avatar

Check inside the frame, behind steering box. Have fun with this one.

User Avatar

The 1988 Ford Taurus turn signal flasher relay switch is located beneath the drivers side dashboard. The turn signal flasher relay switch will be above the brake pedal.

User Avatar

There is no 1988 Ford Explorer. The vehicle went into production in 1990 for the 1991 model year, replacing the two door Bronco II;. As for the Bronco II, there isn't an OBD port.

User Avatar

The easiest way to fix a 1988 Ford Bronco gas hose leak is to replace the hose. You can also patch the week in the hose.

User Avatar

The 1988 Ford Taurus cooling fan relay switch can be found on the front drivers side quarter panel. The fan relay switch should be labeled as such.

User Avatar

On a 1992 Ford Bronco : The electric fuel pump is INSIDE the fuel tank

User Avatar

According to www . ford parts . com ( no spaces ) For a 1988 Ford Bronco , 302 cubic inch V8 engine The spark plug gap is ( .044 inch )

User Avatar

You have to take apart the steering column, remove the steering wheel, remove the ignition switch, and it's a pain in the butt.

User Avatar

A 1976 Ford Bronco would still have a carburetor for the engine , so it does not have a fuel pump shut off switch ( inertia switch ) like the Ford fuel injected engines do ( that use an electric fuel pump ) * if that is what you mean

User Avatar

The MAF is located at the air cleaner you should see a wire connector leading to the air box and that's it.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.