It is located behind the center of the plenum. Which some would consider the intake on this particular car. It is the little round thing up close the center of the fire wall on the car. It is kind of hard to see. It is easier to find if you follow the fuel hose behind the intake.
On a 1995 Monte Carlo, the fuel pressure regulator is located on the right side of the engine. The regulator is on the lower right hand side of the cylinder valves.
What regulator are you refurring to, the fuel pressure regulator... its located on top of the throttle body, its the round thing that's held in place with 3 star screws.
The pressure regulator is located on the pass side of the fuel rail. It has a snap ring on it and all you have to do is take the snap ring off and pull it out. The fuel pressure regulator on a 1995 Eagle Talon non-turbo is an integral part of the fuel rail and is replaced as a unit.
fuel pressure regulator
The engine computer is the voltage regulator.
The voltage regulator is an integral part of the alternator.
Hi. It is located behind the TBI right where the two fuel lines go in. To replace it you have to remove the carb, and remove the top and lift the whole top off, under there you will see the regulator.
39 to about 42 is what the regulator will put out
The pressure regulator is part of the assembly, that round thing on the top of it, where the fuel line connects. YouÊneed to crawl under the truck to take a look, if there is a fuel leak it would smell all the time.
It is on the fuel rail on the return side. The rail meaning where the fuel injectors attach.
The engine computer is the regulator.
Fuel Pressure Regulator is located on the fuel rail.Fuel Pressure Regulator1. Disconnect the negative battery cable.2. Properly relieve the fuel system pressure.3. Remove the air cleaner outlet tube(s).4. Remove any necessary components to access the pressure regulator.5. Disconnect the vacuum hose from the pressure regulator.6. Remove the pressure regulator attaching screws.7. Remove the pressure regulator from the fuel rail.To Install8. Discard the O-rings on the pressure regulator and replace them with new ones.9. Lubricate the O-rings with clean engine oil.10. Install the regulator into the fuel rail and tighten the retaining screws.11. Connect the vacuum hose to the regulator.12. Install any components removed to access the regulator.13. Install the air cleaner outlet tube(s).14. Connect the negative battery cable.