If you have a fuel injected engine it is in the fuel tank. If you have a carb model it is located ( from the driver seat ) on the front right side of the engine at the bottom of the engine. There is a trick to holding the push rod up on these. There is a short bolt in the front of the engine near the fuel pump that you will remove, install a longer bolt in the hole to pinch the push rod tight, change out pump. remove long bolt and install short bolt. hole must have short bolt or it will leak oil excessively. The only purpose of this hole is to aid in fuel pump change.
If you are looking for an inertia switch on a Chevrolet C30 truck, there isn't one. Chevrolet does not use reset switches.
from a remanufactering website
Engine and engine parts: 1988 to 1995 Body parts : 1988 to 1999
Depending on the year. Early S10's up till 88 was located on the passenger side kick panel. The later ones are located behind the glove box.
The oil pressure sending switch on a 1988 Chevrolet Celebrity with 2.8L V6 is located on the bottom of the block near the oil filter.
if 350 1- 8- 4- 3 -6 -5- 7-2
Chevrolet doesn't have a fuel reset switch. That's a Ford thing.
The 1988 Mitsubishi pickup truck data link connector is located on the bottom of the drivers side dashboard. The gauge link connector will be to the left of the steering column.
On the firewall, passenger side.
If it is running on the battery only then that means the alternator is not charging the battery.
1988 to 2000 GMC & Chevrolet pickup truck parts are, for the most part, interchangeable.
= Fuel Injector, 1988-95 GMC TRUCK C SERIES [INCLUDES TRUCK & SUBURBAN] 5.7L = Where is the module for the fuel injectors located?