It is in the fuel tank.. You should obtain a HAYNES manual for this job. NAPA stores.
Where is the Water Pump located and how do you replace it on a 1990 Chevy Corsica?
remove the two nuts holding the master cylinder on the power brake booster
located in the fuel tank of a 1992 corsica ,it may be the same for your model if this is so you may need to drop the tank . I would notadvice you to take on this job unless you have to.
Not an easy job requiring special pullers and tools. I suggest taking it to a garage.
On the bottom of the motor.
A Haynes or chiltons manual has the how to. Or do a search for a forum for Chevy corsica specific
where is the over drive solenoid located on a 1989 Chevy Corsica
It will be on the back side of the engine where the distributor used to be on older engines.
its behind the coil packs on the back of block
It will take an experience mechanic approximately 8 hours to replace the timing belt in your 1992 Chevy Corsica. The 1992 Chevy Corsica does not have each timing chain, it has a timing belt.
16.5 to 17.1 gal
cost to replace heater core 1994 corsica
Correction: It is a 1995 Chevy Corsica. Not a 1996.
Since the 92 Chevy Corsica is equipped with SRS (Saftey Restraint System), ie: Airbags, which is located in the steering wheel. In order to replace the turn signal switch you must remove the steering wheel. Therefore I would only highly advise you to take it to a dealer to have this done.
in the glovebox.
1 for each cylinder a 6 cylinder has 6 a 4 cylinder has 4 and so on.
IN THE ALTERNATOR
You'll find the location for the 4 & 6 cylinder in this pic. http://autorepair.about.com/library/faqs/bl826b.htm
The Chevy Corsica headlight relay switch is located in the fuse box. The headlight relay switch will be in the third column.
The side view mirror on a 1995 Chevy Corsica is mounted by screws. Remove the screws and panel for the mirror on the inside of the vehicle. Pull and replace the unit.
The 1994 Chevy Corsica fan relay switch is located beneath the passenger side dashboard. The fan relay switch should be labeled as such.
yes you need to replace head bolts
in the front of the motot
under washer reservior.