It does not have a reset button or inertia switch.
GM vehicles do not have inertia/reset switches.
There is no ECU reset button.
doesnt have a reset, it only has a relay under the hood.
A 1991 Oldsmobile does not have a reset button.
A 1991 Chrysler does not have a reset switch.
Press reset button assembly located in trunk on driver side fender under carpeting
Push the reset button.
Gm does not use reset/inertia switches
People will be able to help you out a lot better if they know what reset button you are looking for. Make sure you say model, year, and what engine is in the car. Will be looking for more specific question so we can help you out.
The 1991 Ford Probe spark ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
the dealer should of reset it when they did the service. To reset the maintenance required button, insert your key into the slot next to the required maintenance button on the dash and push it in. It will reset the button to "green".
behind the steering wheel on the speedometer for the car
Check in the front passenger footwell , under the front edge of the carpet , just to the right of the transmission hump . I believe that is where the fuel pump inertia switch ( shut off switch ) is located in a 1991 Ford Explorer
I believe only Ford uses them.
I believe there is a button in the trunk. I will check my manual
It doesn't exist.
There is a reset button on the passenger side under the dash. Turn the ignigion on but don't start the car. Press and hold the reset button for about 5-15 seconds. Turn off ignigion and turn back on. It should reset then. If not, push the button with the ignition off and then turn the car on after the 15 seconds.
what type transmission fluid uses for a 1991 ford probe
General Motors products do not use inertia/reset switches.
I found the reset switch on the left side trunk hinge on a 1988. Press the button to reset. Should be similar for yours.
Plymouth does not use inertia/reset switches
The fuel pump inertia switch is located in your right front passenger area. It is located on the right side of the transmission hump on the toe board, just under the edge of the carpet. If you don't see any gas leaking, or smell any gas, push the button down that has popped up on the top of the switch. This will allow power to go to your fuel pump.
It is located in the lft rear of the vehicle in the jack compartment. It should be a little red button. If you are thinking this need to be reset because it is not starting listen for the fuel pump when turning the ignition on, if you hear it buzzing this is not the problem.