by left leg under dash. And left engine compartment.
The heater valve is located behind the dash above and to the right of the accelerator pedal. The heater core is right beside it. It is operated by a linkage to the slider on the heater control panel.
It requires a hammer and some highly explosive gear. Unfortunately it will break in the process.
To remove and install a door mirror on a 2000 Mitsubishi Mirage, the door panel needs to be removed on the inside of the door. First remove any light lenses in the door, then unfasten the clips holding the door panel on. Then remove the mounting bolt for the mirror. Put in a new mirror, replace the door panel and the light lenses.
There is no way to answer this question without information on what is broken. "dash panel" can be a piece of plastic trim, or one or more of several electronic gauges.
The relay for a 99 Grand Marquis heater is located on the kick panel on the driver's side of the car. The relay is located under the kick panel cover.
Your gauges might not work on the 1997 Mitsubishi Mirage because of exposed wires or a short in the wiring. This could cause the problem when there is moisture or a lack of moisture in the panel. You might also have a faulty fuse.
The fuse panel layout for the 1996 Mitsubishi Galant has 13 positions, with three spare fuses. The actual diagram is located in the owners manual.
Behind A/C and heater control panel, in center console.
its located under the scuttle panel next to ur heater motor.
It's located under the driver's side instrument panel
It is on the passenger side beneath the rocker panel.
driver side under steerling wheel panel
It should be located at the passenger side under the instrument panel area next to the heater control box
The heater control valve motor is located below the dash on the passenger side. First remove the glove box, then the lower trim panel. Before removing the lower trim panal remove the center trim around the radio and A/C controls. After removing the lower trim panel, the heater control valve motor is on the left side underneath the automatic compressor controller, connected to the heater control unit.
In junction Box, located under the dash panel (left side).
The fuse for the computer in Mitsubishi Montero 1990 is located under the plate called fuse panel. This is where you will find the fuse.
its behind the trim panel in the pasenger side foot well
its located underneat the dashbourd on passenger side consule panel.
fuel pump is located in gas tank, but there is an access panel located under rear bottom back seat,remove access panel , and you can change fuel pump,.
under the hood or under the dash board on the drivers side!
The heater core is located behind the center console. If you are sitting in the passenger seat of your vehicle, there is a panel to your left at the back of the center console that is held on with velcro at the back and then just some tabs that slide in with the panel in front. Pull that panel off and you will see the heater core right behind and the tubes going through the firewall.
Its located behind the instrument panel in the heater box. Yes you have to remove the dash and the center console.
You can replace the balls in the heater control panel on an XS ARA Picasso by removing the front cover of the heater control panel. The panel lights will then be visible.
remove the bench seat behind the drivers seat. remove the service panel from the interior panel on the drivers side.
it should be in the trunk, you will see a hole in the rear trunk panel where the rest button is located.