The heater (also refered to as the blower motor) for the 1993/94 Plymouth Laser can be found directly above where the passenger's feet would be. There should be THREE screws securing the heater to the car along with a single clip to disconnect it from the electrical. On a scale of 1/10, replacement is about a 3, the only real challenge being the lack of readily available light and it's awkward location. Expect to either shell out about 50$ or hit the internet hard for the replacement.
In a 1993 Plymouth Acclaim, the heater blower motor resistor is typically located under the dashboard on the passenger side of the vehicle. It is mounted near the blower motor, often accessed by removing the lower dash panel. You may need to disconnect the wiring harness and remove screws to access the resistor for replacement or inspection.
behind the engine under the intake manifold on a 1.8L.
When warm, 11 psi min. at idle
electronic control unit (ecu) that would be the computer for your engine
behind the engine under the intake manifold on a 1.8L.
como remplasar blower ac heater paseo 1993 toyota
my 6 bolt is 4321 with the 1 being on the drivers side.
there is no dip stick its a bolt on the bottom of the tranny
1-3-4-2
on a 1993 dodge truck They should be right behind the front bumper
5w30 or 10w30
5w30 or 10w30