where is the transmission control system on a 1996 chevy silverado 2 wheel drive 5.7
where is the over drive solenoid located on a 1989 Chevy Corsica
The drive line is the transmission,rear ends,driveshafts, transfur case and axels.
on my 2000 Chevy Venture, it's the one that sits pretty much on the top of the belt drive.
under the battery plate
In the back end of the transmission.
when you put drive chevy blazer 2002 ls 4wd it turns off, what's the problem
Too my knowledge there is no such animal. Describe the part and what it does, where it is located.
My service ride control appears on the control panel of my 1995 Cadillac SLS Sedan Seville.I need to know what it looks like and where it is located on the car to replace it?
There is a problem with your wheel speed sensors. This is common.
The fuse located under the hood in a 2001 Chevy Tahoe is for all wheel drive. If the four wheel drive stops working this is a fuse to check.
The 99-2002 camaro 3.8 V6 doesn't have Idle air control valve. It is drive by wire control. Many of the parts dealers have the wrong data that 95-02 3.8 camaro have the same Idle air control valve location, and sell the wrong part.
Left rear of the transmission on 2 wheel drive trucks.
Try changing the ignition switch located on the steering column
Left side (drivers side) of transmission.
On the front axle, passengers side of carrier housing.
It is located on the transfer case this is the motor that shifts your four wheel drive
It should be located at the output end of your transmission, before the drive shaft. It should have wires (usually two) coming out from it.
No , a 1986 Chevy Caprice is REAR wheel drive
TCCM Transfer case control module
If it is a 4-wheel drive then it is screewed into the transfur case, if it's not then it will be on the transmission tail shaft.
speed sensors are located on front hubs remove the wheel and you will see what looks like a serated disk the sensors are located adjacent to these These sensors are for the ABS and do not control the speedometer. The vehicle speed sensor is somewhere on the transmition or transfer case. Exactly where I am also trying to find out.
I am fairly certain that it is located in the rear end of the trans where the yoke from the drive line enters and is reading revolutions of your drive line...yes even if front wheel drive.
The chip is located inside the ECM (engine control module). There is an access cover on the ECM that will expose the chip. A special tool is used to r & r the chip as not to damage the prongs.
A c10 is 2 wheel drive and the k10s are 4 wheel drive.