answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Where is the ignition control module located on a 1992 Geo Metro?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the transmission control module 1995 Geo Metro?

it is in the transmission


Where is the transmission control module on a 1993 Geo Metro?

THE TCM is located on the left side of the steering column , It is a gray metal box roughly 4"x 4" with 2 white connectors


On 91 Geo Metro Convertible .Why do you have to run a hot wire to the coil to get it to run.I have replaced the ECU and that did not work?

Does it have an ignition control module? That may be the cause. Or possibly a MAP sensor or a Crank position sensor or Cam position sensor. Check those first.


Where can you buy an ignition switch for a 1997 Geo Metro?

www.advanceautoparts.com


How do you test a Geo Metro 1995 ignition coil?

A 1995 Geo Metro ignition coil is tested by measuring the resistance across the coil. If it exceeds the manufacturer's recommendation, it must be replaced.


Where is Metro State College located?

Metro State College is located in the state of Colorado.


Where is the Geo Metro 1997 coil ignition placed?

Firewall Drivers Side


Where is the control module 1992 Geo Metro?

Had the same problem. Looked up what the module was supposed to look like but could not find anything like it in the engine compartment. Looked it up in Haynes book and identified the wires. Ends up it was about the size and shape of your thumb and was wrapped up in the wire bundle just below the right hood hinge. Good luck.


In the ignition system of a 93 Geo Metro 1.0 where should the dwell on the points be set?

electronic ignition on the 93, no controll. just set your timing.


Why does the 15 amp ignition fuse keep on breaking on my 2000 Chevy Metro?

Well the thing is That the car Cranks but I does not start or turn over. I traced it to the 15 amp ignition fuse in the dash fuse box which was broken. I replaced the bad fuse and the Metro started but with in 2 minutes the fuse broke again. I have no clues I have found plenty of clues on -ine but but no answers.Thanks,Metro Owner.Answerbecause a Chevy metro has a 30 amp ignition system. It indicates 15 AMPS on the Fuse Panel!!


How many cds did metro station?

One titled Metro Station, a Control EP and a Kelsey EP


How do you set the ignition timing on a 2000 Geo Metro?

Turn the distributer to the right very slightly