0
It is inside the distributor, If you look at the right side of it you will see some electric
wires and they are hooked to the module. Just remove the cap and then 2 screews that hold the module on the base of the distributor.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do i change the ignition module in a 1998 suburban?
Begin by removing the wiring harness from your 1998 Chevrolet Suburban ignition module. Remove the ignition module retaining screws. Reverse the process to install your new ignition module.
Where is the dura spark ignition module located on a 1991 Ford probe?
The 1991 Ford Probe spark ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
What produces spark on my 1997 suburban 5.7?
The ignition module that's in the distributor.
Where is the ignition module on a 1991 Oldsmobile regency?
The Ignition Control Module is on the top left hand side of the engine under the Ignition Coils.
Wiring order for a 1991 Pontiac SunBird ignition module?
what is the color order of the wires to a Pontiac Sunbird ignition module
What would stop your injector from firing on a 92 Chevy Suburban?
Ignition module in the distributor.
91 Honda Accord ignition module replacement?
how to put in a ignition on a Honda accord 1991
Where doest the wire come from that energizes the fuel pump relay on a 1989 Suburban TBI?
ignition module
Would like info on ignition troubleshooting for 92 Chevy Suburban?
test ignition coil,ignition module,pick-up coil,electronic spark control,and knock sensor
How do you bypass the resistor in the key ignition on a 1991 firebird?
buy a DFVATS Bypass Module from www.bakerelectronix.com
What is the BDCT ignition timing degree on a 1991 Chevy Suburban 5.7?
you should set it at 0 degrees btdc
Where is the ignition control module located on a 1991 exploder?
It is mounted on the radiator support frame in front of the battery
