Auto Parts and Repairs
Starters and Ignition Systems
Mitsubishi Eclipse

Where is the ignition module on a 1996 Eclipse?

123

Top Answer
User Avatar
Wiki User
Answered
2014-10-07 01:53:17
2014-10-07 01:53:17

The 1996 Mitsubishi Eclipse ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


The engine computer is the ignition module.


there is no ignition control module on the 1996 model its all through the PCM


Only the EEC-IV ignition systems ( 1991 to 1995) use an external ICM (ignition control module) . From 1996 on with the EEC-V system the ignition control module is incorperated into the power control module (PCM) mounted in your firewall on the passenger side.


Remove the 3 coils which are help on by 2 5.5 mm bolts each. The module is now free. Remove electrical connector from ignition module. - Tech JK -----------------------------------


If this is the 4.3 engine, it is located on the bracket next to the ignition coil.


It's right behind the fuel trim beside your ignition coil pack


The ignition module is located under the three ignition coils. The same bolts that hold the coils in place also retain the module to the mounting bracket. To find the coils, follow the ignition wires from the front of the engine to where they attach at the rear. The wires clip to the coils.


The Ignition Control Module on a 1996 Ford Thunderbird 4.6 is located inside the EFI or Electronic Fuel Injector. The EFI is the carburetor. Look for a cord that has a connector that resembles an HD Cable.


where is the ignition module located on a 1988 Mazda b2200


The engine computer is the ignition module.


Where is the ignition module 97 explorer




the ignition control module is operated by the pcm,the pcm tells the ignition control module when to energize the coils to enable spark


Begin by removing the wiring harness from your 1998 Chevrolet Suburban ignition module. Remove the ignition module retaining screws. Reverse the process to install your new ignition module.


From 1991 to 1995 with the EEC-IV system there is an external ignition control module mounted on the radiator support in front of the battery. Remove the battery in order to change the module. 1996 and newer with the EEC-V system, the ignition control module is incorperated into the powertrain control module (PCM) that is visible from the engine compartment, in the firewall, on the passenger side.


No. It doesnt have a distributer. Its A D.I.S. set up. (Distributerless Ignition System).


under the distributor cap. it is black plastic and has 2 small screws in it New answer: Sorry but that year did not use an ignition module. It use a crank senser and cam senser. If this is a S10 with the 4.3 L engine, it has an ignition module and it is attached to the bracket that also holds the ignition coil on the passenger side of the engine.


CAR GUYS.COM OR YOU CAN GO TO YOUR LOCAL LIBRARY



Passenger side of the firewall, the engine computer is the ignition module.Passenger side of the firewall, the engine computer is the ignition module.


the ignition module is located in the distributor


ignition control module is under the distributor cap


The engine computer is also the ignition module.


its located on driver side head on top of block little black module with plugwire running out of it



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.