Jeep Liberty
Ford F-150
Ford Ranger XL

Where is the intake air temperature sending unit on a 2002 jeep liberty?

262728

Top Answer
User Avatar
Wiki User
2007-09-08 10:34:19
2007-09-08 10:34:19

For a Liberty 3.7L engine, the Intake Manifold Air Temperature (IAT) sensor is installed into the left side of intake manifold plenum. Prior to removing this, ensure to clean around the unit so dirt doesn't fall into the opening. Removal is about 1/4 counterclockwise turn.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Temperature Gauge Sending Unit The sending unit is located in the front section of the intake manifold in the vicinity of the thermostat.

User Avatar

The 2002 Jeep Liberty came equipped in four engine options. For the 3.7L V6 the intake air temperature (IAT) sensor is located in the intake air assembly. It will be forward of the throttle body, which is the assembly that regulates air intake via its butterfly valve. The OE replacement IAT for this application is Standard Motor Products #AX69.

User Avatar

The oil sending unit is located on the back side of the engine on a 2002 Lancer. It is under the intake manifold.

User Avatar

The intake air temperature sensor is under the intake manifold on the 2002 Land Rover Freelander. It is on the top rear section of the engine.

User Avatar

The 2002 Ford Escort zx2 does have an air intake air temperature sensor. The sensor is at the top of the engine on the drivers side.

User Avatar

The temperature gauge sensor on the 2002 F150 is located on the driver's side of the vehicle and under the intake. This is almost impossible to remove without removing the intake itself.

User Avatar

It's located to the left of the oil filter.

User Avatar

It is on the intake manifold near the thermostat housing.

User Avatar

It is plugged into the air intake just next to the intake manifold. Right next to the smallest hose connecting to the air intake.

User Avatar

top of block pass side under edge of intake at front of motor

User Avatar

It is located on the intake manifold near the thermostat housing.

User Avatar

Answeron what? on a 2002 grand am it is right on top of the big black tube coming from the air filter to the engine

User Avatar

I believe that the intake temperature is integrated into the mass air flow sensor on this car. which is located under the air filter box at the rear of the engine.

User Avatar

The rear of the generator, right on the manifold

User Avatar

The temperature sending unit is on the back of the crossover pipe under the coil pack. When the sensor goes bad, the cooling fans are designed to run constantly, keeping the engine from overheating.

User Avatar

It's at the very back of the block, top-center, under the intake manifold.

User Avatar

It is integral with the Maf sensor on the air box

User Avatar

It is on the intake manifold near the thermostat housing.

User Avatar

It is located on the intake manifold near the thermostat housing.

User Avatar

the answer is no. 2002 was the first year the liberty was made. in 2003 they change the computer modules..the only engine you can put in a 2002 jeep liberty is a 2002 engine

User Avatar

it is located on compartment gloves on passenger side.all you need to do is open the compartment all the way then you can see it.

User Avatar

You could have several problems. The thermostat could be stuck open or the temperature sending unit could be defective.

User Avatar

At the top front of the engine, in between the alternator and Air Conditioning Compressor.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.