answersLogoWhite
Cars & Vehicles
Chevy Silverado
Subaru Legacy
Ford Explorer XLT

Where is the knock sensor on a 1997 subaru legacy gt 2.2 liter?

91011

Top Answer
User Avatar
Wiki User
Answered
2007-12-31 18:32:53
2007-12-31 18:32:53

It is threaded into the block, under the intake manifold.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The 1993 Subaru Legacy 2.2 liter engine ignition timing is the sequence that allows the engine to run smoothly. The ignition timing is synchronized with the crankshaft position sensor.


The knock sensor is located under the Intake Manifold and there is a knock sensor 1/ knock sensor 2 on this model,the 2 is the one in the rear.



I believe it is on the driver side, top of the engine block, below the point where the air filter canister connects to the thottle body. look for a single bolt thru a sensor (diameter of a quarter) and wires attached. Do I relpace the snser from under the hood or do I have to get under the car?


knock sensor location is under the intake manifold you have to remove intake their is two knock sensors front and rear


I don't think it has a knock sensor ( I know that the 4.0 liter V6 engine in my 1995 Ford Explorer doesn't have a knock sensor )


The first year of a knock sensor on a 4.0 liter OHV was 1996 ( OBD II / EEC V )


"TPS" = Throttle Position Sensor. It's the sensor that tells the computer how far your foot is into the throttle. It should be connected to the butterfly valve that opens to allow more air into the engine.


The engine temp sensor on a Subaru 2.5 liter is located on top of the engine near the radiator output. It constantly monitors the coolant temperature and helps to vehicle adjust flow as needed.


The 2002 Silverado 4.8 liter engine knock sensor is located on the back of the crankshaft. The back engine cover will need to be removed in order to view the sensor.


Yes , one of Ford's websites lists a knock sensor for the 3.4 liter SHO engine in a 1997 Ford Taurus


where is the knock located on 2001 nissan altima 2.4


The knock sensor is on the passenger side of the motor along the top of the oil pan about half way on the block.


the knock sensors 1 and or front and back are locaded under the intake


There are two of them located in the block under the intake manifold.


It should be on the side of the engine block over by the starter.


I believe they only made the 2.0tt in 1995


The 1997 Chevy 1500 pickup truck 5.7 liter engine knock sensor can be found on the front of the engine. You will need to remove the front engine cover in order to access the sensor.



Back of the block, drivers side, close to the head


A knock sensor is a low voltage sensor that sends information to the ecm, and then the ecm makes changes in order to try and control the knocking. In my experience all knock sensors are located on the engine somewhere because that's where the knocking occours.


From the videos on YouTube. They are under the intake.



on the lower part of the engine near the cats


it is on back side towards rear end of engine.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.