The PGM-FI unit is located under carpet at the passenger side. It covered by frame. Good luck. The ignition control module of any late model Honda/Acura product is always the PGMFI computer, which controls all fuel delivery and ignition timing coordination. Now, if you have a problem, that is ignition related, first replace the plugs, then the wires, and shortly after the ign coil itself. That's how you approach a Honda ign prob.
where is the ignition module located ina 2000 integra acura
The 2002 Acura airbag control module is located on the firewall in the engine compartment. The airbag control module will be on the drivers side of the firewall.
within the distributor
Under the dash
The PGM-FI unit is located under carpet at the passenger side. It covered by frame. Good luck. The ignition control module of any late model Honda/Acura product is always the PGMFI computer, which controls all fuel delivery and ignition timing coordination. Now, if you have a problem, that is ignition related, first replace the plugs, then the wires, and shortly after the ign coil itself. That's how you approach a Honda ign prob.
The DRL control module is located under the steering column on the left hand side!
ignition control module also called the ignitor No it is not the ignitor. An ignitor helps start the car however it does not keep the car running.
yes, if you have the correct harness for the module for that setup.
The sensor senses when the engine is pinging or called spark knock. It then sends a signal to the engine control module. The engine control module then temporarily retards the timing until the pinging stops.
There is no fuse for that. The transistor module controlling the blower is blown out. It's inside the console.
Under the dash. Mounted to the firewall. There's a red flashing light on the bottom side of it.
Were are the timing marks on a 1991 acura legend