Want this question answered?
Master cylinder mounted on the firewall, drivers side.
Open the hood and you will be looking for a transparent cylinder shaped contaner near the top of the engine compartment on the drivers side. That part is called the master cylinder resivor, it holds most of your brake fluid. There should be a cap on the top that you can open and add fluid if needed.
Need to know how to assemble 95 Chevy clutch master cylinder?
Replace the master cylinder.
How do you change a Master Cylinder and hydraulic clutch line for a 1998 Chevy S10?
The clutch master cylinder on a Chevy S10 is replaced by disconnecting the metal lines, unscrewing the retaining bolts, and removing it from the housing. A new master cylinder can then be put into place and reattached.
Fill resivor, leave cap off, Open the bleeder on the slave cylinder until you get a ready stream flowing then close the bleeder. Refill resivor and keep cap off. Then pull the pin out of the slave and push it in slowly the whole way with a screwdriver. Repeat until the resivor has no bubbles. Replace the pin in the slave and refill the resivor, put the cap on and your done.
remove the two nuts holding the master cylinder on the power brake booster
on tims HEAD
Which part do you want to replace? The slave cylider or the master cylinder? The hydraulic line and master cylinder.
use a 1.6-liter 4-cylinder engine
The 1.6 liter four cylinder has a timing BELT and the 2.0 liter four cylinder has a timing CHAIN