0
Where is the noise coming from under the hood of your 1996 grand voyager van after you have change out the belt the tenisor wheel and idle wheel?
Wiki User
∙ 16y ago
The noise can be 1 of acouple of things, could be that the belt is on slightly crooked... or dirt being on belt and tensioner pulley or the tensioner pulley is on slightly crooked causing the noise... the belt wont slip off, but it will just make that noise... just put some oil on the belt and that would be enough to keep it lubricated and noise free... or could take it all back off and put it back together, checking to see if everything is nice and straight, and dirt free.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you change the thermostat in a grand voyager?
where is thermostat in 2000 chrysler grand voyager ??
How do you reset oil change light on Chrysler grand voyager 1997?
how do you reset change oil light on chrysler grand voyager minivan 1997
How do you change the transmission fluid in a 1997 Plymouth grand voyager?
what do I need to change the 1997 Plymouth voyager transmission oil
Does the 2004 grand voyager have a timing belt What is the mileage to change?
The 2.4l does, change at 100,000 miles.
What do Americans call the Chrysler grand voyager?
The Plymouth Grand Voyager.
How do you change out the clockspring on a plymyth voyager?
check to see if there was a recall. I have a 1996 Plymouth grand voyager and the garage replaced mine free of charge.
How do you change a water pump on a 1999 Plymouth grand voyager?
Depends on what size engine it is on...
Why won't the climate control in my Plymouth grand voyager se change modes?
The panel is broken. Replace it
How many quarts of ATF fluid with filter change for 2000 Chrysler grand voyager se?
About five
Will a 1995 grand voyager battery cable work with a 1996 grand voyager?
If they have same wiring then yes...
What is difference between Chrysler voyager and Chrysler grand voyager?
Grand is l o n g e r
What does it mean when a 1998 Plymouth Grand Voyager jerks right before coming to stop?
There are several possibilities. You could have a caliper that is sticking or you have a warped rotor.
