it doesnt have one!!!!
Engine seal? Valve cover? Oil pressure sending unit?
valve stem at back of intake press and it will release the pressure make sure to pull the relay to fuel pump
you will see oil all around the valve cover and running down the side of the block.
The oil relief valve is a spring,check ball,and roll pin made into the oil pump.If your relief valve is in doubt replace the whole pump (less than $20.00) It's cheap insurance.
It doesn't have one. If you want to relieve the fuel pressure in the system simply remove the fuel pump relay while the engine is running, it will run briefly until the pressure is gone.
Yes, but 1991 rims will NOT fit a 1993 camaro
Most likely the oil pressure sending unit is defective, replace.
no it will not
MUST have 9 to 13 LBS. NO lower are higher are you will have problems.
I would replace the gasket and be SURE that the PCV valve is working properly. If not it will cause pressure to build in the crankcase ans it has to vent somewhere.
There were no IROC Camaros in 1991
Yes.