Under the right exhaust manifold towards the rear of the engine.
The 1985 Toyota Camry oil pressure sender is located on the left-hand side of the engine. The oil pressure sender will be just above of the oil pan.
it may be the oil pressure sender located on the engine
It is on the front of the engine, just above the oil filter.
The oil pressure switch and oil sender for older 454's are mounted on the lower left front of the engine block just above the oil pan.
The oil pressure sender or switch is located at the rear of the engine, behind the distributor.
Oil pressure sender /fuel pump switch for 1995 Pontiac transport 3.1 is located between oil filter and starter at front of engine.
The oil pressure sender on a Mazda B2500 2.5 is located on the bottom of the engine near the oil pan. It constantly monitors the output and circulation of the oil pump.
On the 4.0 L OHV engine, it is on the driver's side of the engine below the power steering pump.
i believe that the st has a 4afe (1.4l) engine. if that is the case the pressure sender is below the alternator and to the left of the oil filter. if it has a 3sfe (2.0l) the sender is on the drivers side of the cylinder head on the front.
The oil pressure sending unit on a 5.9L V8 is on the top rear of the engine next to the distributor.
The oil pressure sender is located on the front of the engine. it is on the drivers side of the oil filter mount assembly , just over the starter motor. The starter motor is not in the way to re/re the sender unit.
The temperature sender is a one wire sender and should be located on the driver's side of the block, near the firewall. It will be located almost directly below the oil pressure sender. You can also check thegauge by touching the wire to ground. When grounded, the gauge should read full hot. Hope this helps.