0
The oil pressure sender or switch is located at the rear of the engine, behind the distributor.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you change the oil filter sending unit of a 1999 suburban?
How do you change the oil filter sending unit of a 1999 suburban?
Oil pours out of a 1993 suburban?
if it POURS out, check drain plug, oil filter and oil pressure sending unit
Where is the oil pressure sending unit located on a 1996 ford ranger xlt?
On the ( 4.0 liter EFI , V6 engine ) in a 1996 Ford Ranger : The oil pressure sending unit is on the drivers side of the engine , below the power steering pump
Where is the fuel tank pressure sensor on a 1998 GMC Suburban?
That would be attached on top of the fuel pump/sending unit assembly.
Where is the fuel sending unit on a 1987 Chevy Suburban?
Your fuel sending unit is in the gas tank, mounted from the top.
Where is the Oil pressure sending unit on a 1996 ford 5.8?
should be right next to the oil filter
Where is the oil pressure sending unit on a 1996 Ford Explorer v6?
the sending unit is located near the bottom of the block on the left ( driver side) it is on the same harness as the oil level switch
How do you Remove oil pressure sending unit on 2.7 liter Chrysler engine?
Remove the oil pressure sending unit retaining ring. Remove the wiring harness from the sending unit. Poll the sending unit out of the engine.
Where is the oil sending unit on a 1996 Dodge Stratus?
On most cars, the oil sending unit is just above the oil filter, although it can vary depending on the engine. On the 1996 Dodge Stratus with the V6 engine, it is above the oil filter. You will need to remove the filter before replacing the oil sending unit. The oil sending unit detects the oil pressure; it is different than the oil pump.
Where is oil pressure sending unit for 1998 Mitsubishi mirage?
Were is the oil pressure sending unit on a 95 mitsubishi miaage
Where is the oil pressure sending unit 05 gmc sierra?
The oil pressure sending unit on a 2005 GMC Sierra
Were is the oil pressure sending unit on a 1996 dodge Cummings?
It should be on the drivers side behind and below the injection pump.
