OK, but I'll bet you will be sorry you asked.... The pressure sender is located on the firewall side of the motor, behind the alternator and under the right side manifold support bracket. If you get under the car, look up between the firewall and the engine, about halfway up, and you'll see a ridge about 1" in diameter running the entire length of the engine block. This is the oil galley. The oil pressure sender is screwed into the right end of this galley, and has one tan wire (or one tan & one tan/blk if your car has a pressure gauge). Terry
On the 1995 Saturn SL1 The oil pressure sending unit is the sensor closest to the alternator. The unit is on the back of the block.
The oil pressure sending unit is located on the back of the block. it is the sensor located closest to the alternator.
We need to know which sending unit you speak of. There are several on that vehicle such as temperature sending unit, oil pressure sending unit and fuel gauge sending unit.
The 1994 Ford F3 50 pickup truck 7.3 liter engine oil pressure sending unit can be found on the left-hand side of the engine. The oil pressure sending unit will be near the front of the engine.
The oil pressure sending unit is on the top rear of the engine, next to the distributor.
Low oil pressure or a defective oil pressure sending unit.Low oil pressure or a defective oil pressure sending unit.
Back of the motor, next to the oil filter...
The oil pressure sending unit is located on the oil filter housing. Look above the filter and you will see a single wire going to the unit. You will need a sending unit socket to remove it. The tool can be purchased at any auto parts store for a nominal fee.
Remove the oil pressure sending unit retaining ring. Remove the wiring harness from the sending unit. Poll the sending unit out of the engine.
The oil pressure sending unit on a 2005 GMC Sierra
Were is the oil pressure sending unit on a 95 mitsubishi miaage
Do you mean the Temp sending unit, oil pressure sending unit, or fuel level sending unit?
Which sending unit? Oil pressure sending unit? Engine temp sending unit? Fuel gauge sending unit?
No, a sending unit is for a gauge, and the switch is for a warning light.
Temperature Gauge Sending Unit The sending unit is located in the front section of the manifold in the vicinity of the thermostat.
The 1986 Chevrolet Cavalier oil pressure sending unit can be found on the left-hand side of the engine. The oil pressure sending unit will be above the oil pan.
If you checked the pressure with the sending unit in the car, it is possible the sending unit itself may be bad!
Oil pressure sending unit Where is it at on the engine
It is on the back of the engine, just to the side of the distributor.
It is screewed into the top of the block right behind the distributor. It is HARD to get to.
Oil send unit 4.9.l
Yes you can. Sending units in saturn does sit next to fuel pump and you just need to unplug the wire hook up and repalce the sending unit.
Oil Pressure Sending Unit LocationBuick positioned the oil pressure sending unit on the engine block, just below the power steering pump.
There is more than one sending unit, such as engine oil pressure sending unit, engine temperature sending unit and fuel gauge sending unit to name a few. Need more info.
It has several sending units such as a fuel gauge sending unit, oil pressure gauge sending unit, temperature gauge sending unit, need to know which one you are looking for.