Auto Parts and Repairs
Ford Thunderbird

Where is the oil pressure switch located in a 1996 ford thunderbird 4.6L?

123

Top Answer
User Avatar
Wiki User
Answered
2012-01-01 20:41:01
2012-01-01 20:41:01

It should be found close to the oil filter.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


Type your answer here... oil pressure switch location



The pressure switch for the air conditioning system on a 1996 Ford Windstar is located in the accumulator. It triggers when the compressor will turn on and off.


The oil pressure is located on the side of the engine block. The switch has a black plug with three wires connected to it.


Yes, it is located on the driver's side top corner in the trunk. Pull the liner back and you cant miss it.


The 1996 Ford Thunderbird fan relay switch is attached to the electric fan motor. The fan motor is attached to the fan blades.


Can you put a 1994 thunderbird motor in a 1996 thunderbird?


The oil pressure switch is on the top rear of the engine, there is only one.



Hi'I also have a 1996 Millenia, just changed my out. At front of your engine 2.5 just over your oil filter, you have to unplugg the pressure switch wire befre you can get the socket on it.


The oil pressure sender or switch is located at the rear of the engine, behind the distributor.



on the cylinder head on the drivers side of the vehicle standing in front of the vehicle just above the engine block there is a round switch that's your oil pressure switch


The oil pressure switch on a 1996 Chevrolet Cavalier is on the rear of the engine block. It will be directly above the oil pan.



Check on top of the accumulator/drier at the passenger side firewall




The electric fuel pump is inside the fuel tank


The ECT or the Engine Coolant Temperature Sensor is a switch. This switch is located on the bottom of the radiator in the 1996 Camry.


The heater switch on a 1996 Ford Contour is under the passenger side dash. It is located behind the glove box.


It is located on the discharge side of the compressor. On a 2.4L engine you will need to jack the vehicle up to get to it.



A Chrysler LHS does not have a reset switch.


There is no manual low pressure switch but there is a low pressure switch that turns on the oil light and shuts off the fuel pump to prevent the engine from running with no oil pressure.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.