on the right side of the throttle body
inside the transmission
it should be in the distrubator
I need to find where are my vacuume hoses on a 1992 Nissan maxima se...
what are the torque specs and sequence for a 1992 Nissan maxima manifold
IF YOUR ENGINE IS A VG30E..ITS ON THE BACK OF THE TOP PART OF THE INTAKE MANIFOLD TOWARDS THE DRIVERS SIDE IT THREADS IN AND HAS A HOSE RETURNING TO THE REAR VALVE COVER............ALL THE BEST .............BUDDY MACK..
It is in the console, remove the panel where the passenger's left foot would be.
its in the gas tank
The 1992 Nissan modulator valve can be found on the firewall in the engine compartment. The valve will be on the drivers side of the firewall.
The window fuse on a 1992 Nissan Maxima is located in the main fuse panel next to the hood release. The fuse prevents the motor from drawing too much power or being damaged by a surge.
Your throttle valve switch (position sensor) is bad and need to be replaced.....this is located on the side of the throttle chamber. You can get this from Advance Auto for $60 and is easy to replace...
in the distrubator
the pcv is located on the right top side of the valve cover. it has a hose connected directly to the crankcase cover.(on my car the cover is red)it is simple to replace and costs dirt cheap.NEVER open the hose and take off the pcv when hot. use a wescott for simplicity. specs for 1992 Nissan maxima se, single overhead cam, probably the same,different pcv for dohc though.
The 1992 Nissan Maxima diagnostic socket location can be found on the bottom of the drivers side dashboard. The diagnostic socket will be to the left of the steering column.
If you have a Maxima GXE with the VG30E engine, the fuel filter is located on the firewall on the driver's side. It simply slides into a bracket, and the rubber fuel lines are just held on by 2 clamps. The filter is in the same place on a 1992 Maxima SE with the VE30DE engine as well, but it will be slightly harder to access.
the water pump is in the middle of the timing cover the crank pulley and timing cover has to come off
no because the maxima is a 5 lug and the sentra is 4 lug