the pilot bearing is on the crank center of the fly wheel, the smallest end of the transmission shaft will fit into it after it is assembled.
The cost to replace the clutch on a 1993 Toyota Celica will vary depending on labor and part costs. The clutch for the vehicle costs approximately $67.63 in some stores.
Yes
The clutch bearing for an AC compressor is located in the center of the clutch. If the bearing goes bad, then the clutch is replaced as a whole part rather than changing the bearing.
Make sure clutch, pressure plate, and throw-out bearing are all in alignment
http://toyotacelicas.com/forums/ or google "toyota + forum"
yes if u change the clutch and cam shaft
about $900.00 at a garage
Yes the transmission will fit. But when converting over you will need a clutch pedal, brake pedal, clutch disc, pressure plate, throw out bearing, clutch fluid reservoir as well as the lines to route the fluid. You will also need the shifter cables as well as the shifter itself. Its not an easy task.
That's pretty much a given with changing any clutch or torque converter.
Changing the clutch on these cars isn't really easy. you have to remove all connection and wires going to transaxle. disconnect steering knuckle and half axles. remove the lower suspension support bar. then undo the bolts holding the transmission to the engie and lower out the transmission. then remove clutch off the engine and replace. You can get a clutch kit for a 1990 celica for rough 130 dollars at autozone.
one million dollars and 2 cents
There is no adjustment on the clutch, if it is not disengaging, it is probably the slave cylindar on the transmission. The fluid may be low also.