See "Related Questions" below for more about the VSSAnswerMost newer vehicles include a wheel speed sensor on each wheel that is used to tell when one or more wheel is slipping. The information is used by the ABS system and by the anti-slip feature if present.
The speed sensors are also used as a part of the cruise control system.
Many people seem to believe that there is a governor attached to the speed sensors. There is no evidence that a governor exists on any Ford or GM product.
The coolant temperature sensor on a 1993 Mercury Topaz is located at the rear of the engine. To get to it, you have to remove the driver side fan.
the knock sensor is under intake, must remove intake and it is under two coolant lines.
On a 1997 Mercury Cougar XR7, the temperature sensor is located below the air intake. The sensor should be accessible without having to remove any other parts.
can you tell me where the knock sensor is located on a 3.3l mercury villager
In the dashboard behind the small grill to the right of the steering column.
Where is the camshaft position sensor located on a 98 Mercury Mystique 2.4??
The DPFE sensor is located in the center of the vehicle near the firewall. It is easiest to see and replace if you remove the plastic cover on top of the engine.
The 1999 Mercury Mountaineer 02 sensor is secured to the firewall with two retaining screws. Remove the two retaining screws. Remove the O2 sensor hose. Reverse the process to install the new sensor.
on the dash
On the transmission.
The camshaft position sensor for a Mercury Mystique is located on top of the motor. It is bolted in the same place where older versions of the engine had a distributor.
the elictronic control sinsor at on a 93 mercury villager
It may be located in the airbag sensor control unit.
Idle air control valve sensor is located around the carburetor .
The sensor is on the driver side of the head. It has a single wire to it.
cougar 99 where is coolant temperature sensor
do you mean maf sensor if so it is located on top of air cleaner
on the transmission
remove and reinstall
The 2001 Pontiac sun fire speed control sensor is located on the front passenger wheel. The sensor can be found on the inside of the rotor.
A speed sensor on a 1998 Mercury Tracer is located on the transmission housing of the vehicle. It is placed on top in a secure location to safely measure the speed the transaxle spins.
Crank position sensor is located next to the crankshaft. In order to replace it you might have to remove the timing belt. In the most models you just can remove remove the timing belt cover and replace the sensor.
In the engine compartment
It is located in the distributor unit.
Answer , location of temperature sensorI just changed the Temperature sensor on my Pontiac and it was located on the engine block right underneath the throttle control.