The exact location of the speedometer cable is dependent upon the make and model of your 1994 pickup truck. In general, the speedometer cable goes from the speedometer to the speed sensor.
The speedometer on the 1994 z28 Camaro has both MPH and KPH on it. The KPH are the red numbers on the inside of the scale.
The speedometer does not have a cable on a 1994. It is run by a sesnor on the rear of the trans/t-case.
A worn or frayed speedometer cable will make the speedometer shouter. As the speedometer cable becomes more frayed the speedometer will eventually quit working.
The most common reason for a speedometer to fail is a broken speedometer cable. Loosen the nuts on each end of the speedometer cable. Remove the speedometer cable retaining clips. Reverse the process to install the new speedometer cable.
It doesn't have a speedometer cable. The system is all electronic..It doesn't have a speedometer cable. The system is all electronic..
i want to know what type of antifreeze does 1994 chevy camaro
The speedometer sensor is in the top of your rearend housing.
A 1994 Plymouth Sundance/Duster does not use a speedometer cable. Instead, it uses a Speed Sensor located on the transmission.
The 1994 Chevy Camaro horn is located in the front of the engine compartment. The horn will be on the right hand side of the radiator.
Speedometer cable (most common) Speedometer head Gear on transmission end of speedometer cable
No, because the two years have two different body styles
If your speedometer is cable driven and not electronic, it sounds like the cable needs to be lubricated. You remove the cable from the back of the speedometer and pull out the inner cable and slide it back in while lubericating it with some speedo grease.
under the dash
Most likely it will be a cable speedometer...I don't own a 94 350 so I can't say for SURE, but I do own a 2003 Big Bear 400 and it's a cable speedometer.
I call a mechanic, someone who wouldn't ask the internet how to do it
The gear between the driveshaft and the transmission is broke you need a knew one
it might be grounding out check wires
DOT 3 fluid
You just have to sqeeze the junction of the cable ( white connetion) and it will release
Go to any parts store and tell them what engine you have in your camaro and they will give you the right size.