answersLogoWhite
Starters and Ignition Systems
Nissan Sentra
Late Model 1979-New Ford Mustangs

Where is the starter in a 92 Nissan Sentra and where do the bolts to it go?

232425

Top Answer
User Avatar
Wiki User
2015-07-14 15:06:07
2015-07-14 15:06:07

I have a 94 Nissan sentra but it's the same body style. My starter is located right below all the air intake hoses. the easiest way to find the starter is to take the airbox stuff out and then follow the ground wire from the negative end of the battery (the only wire leading off the negative end) to where it attatches to the transmission. The bolt that that wire attatches to is one of two bolts that attatches the starter to the transmission.

1

Related Questions

User Avatar

how do you remove a distributor rotor on a 92 Nissan sentra

User Avatar

The starter on a 92 Buick LeSabre is replaced by disconnecting the battery, removing the retaining bolts, and lowering the starter. The wiring harness can then be disconnected and a new starter installed.

User Avatar

I have a 92 with a 1.6 and get about 34 miles per gallon.(SMILE)

User Avatar

right next to the tranny, it has a red and black wire on it

User Avatar

The starter is located on the right hand side of the bell housing under neath the motor

User Avatar

remove bolts and replace it how do u think

User Avatar

bottom of engine, passenger side. where the engine meets the transmission.

User Avatar

You take the bolts out of it.... replace with new starter and put the bolts back in Although Chiltons shows the removal of the starter from the car, I can't find the location of the starter under the hood. I think it's quite a distance from the battery, but I'm unsure. Can someone help me - I'm a beginner. Also, Chiltons refers to labeling the wires before removing the starter.... Is a wire directly connected to the battery from the starter? If yes, is it the positive or negative wire. The starter for a 92 Nissan sentra is located above the oil filter. It is not hard to change out. Remove the air filter assbly. Reach down under the air intake mess and remove the first bolt 14mm. Secondly locate a big wire (yellow and black) on the front of the transaxle with a bolt going thru it. Remove that bolt. It goes through the cowling and screws into the top hole on the starter. Swing the starter up and turn and remove wire. 13 mm bolt. Reverse process to install. I used a Beck Arnley rebuilt part number 187-0387.

User Avatar

Disconnect the - battery cableRaise and support vehicleDisconnect wiring at top of starterRemove starter mounting boltsRemove starter

User Avatar

The alternator on a 92 Nissan Maxima is changed by disconnecting the wiring harness, loosening the retaining bolts, and removing the drive belt. The bolts can then be fully removed and the alternator swapped out.

User Avatar

Go to your auto parts store and get a Chilton or Haynes repair manual for your vehicle.

User Avatar

you have to take out the bottom of the back seat and its under there

User Avatar

I had to replace the starter on my 92 and the starter was on the left side at the bottom of the engine .it has three bolts and is a real pain to remove. that's all a can remember .plus it cost about a 100.00 at advance auto . If there is a relay for the starter, you should be able to find it between your pos. batt. connection and your starter, as the batt and starter are often directly linked

User Avatar

Easy enough, 2 torx bolts going straight up from the starter, and dont forget to unhook the electricals.

User Avatar

Remove the positive cable from your 1992 Chevy Lumina battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.

User Avatar

First make sure it is the starter that is at fault. Then take the neg battery cable loose at the batery. Then take off the wiring then the bolts holding it on and work it out.

User Avatar

Disconnect the battery, preferrably the negative post. Two bolts hold the starter to the engine block. They're 13MM or 1/2 inch (same thing basically) Pull the bolts, then disconnect the electrical. The starter is low on the back side of the engine, right in front of the driver.

User Avatar

disconnect the battery cables, remove bolts/nuts, remove wire, pull starter off, bingo~! put the new starter in, put the bolts/nuts back on, put the wire back on, hook the battery cables back up, bingo~! fire it up!!!

User Avatar

how to remove the starter from a 92 s-10 4x2 with a 2.8 engine

User Avatar

The starter solenoid is on the starter.The starter solenoid is on the starter.

User Avatar

Underneath the passenger side of the vehicle. Apparantly it's 2 bolts to remove but you must disconnect the battery 1st.

User Avatar

Which engine is in it ? First disconnect battery remove torque converter cover if it is an auto trans remove starter bolts position so you can remove rest of wires stand starter vertical rotate and let it com out the bottom

User Avatar

The starter solenoid is on the starter.The starter solenoid is on the starter.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.